Hi, could someone tell me if Cisco WAAS can be used for branch to branch optimization? Is this supported? My customer wants it this way so in the topology it will become full mesh implementation. Thanks RegardsAlkuin Melvin
I have confige a pair of Ace appliances with configuration provided by Cisco for this function, in that I have a Global IPv6 address x-lating to an IPv4 real server farm. I'm having no love. Does this functionality work with a static NAT IPv6 to IP...
We have issues with logging in to our ACE, if I want to connect via SSH or HTTP its fine, if though I want to connect via https to login to configure it, I am unable to connect. This was working and these ACEs have been active for approaching three y...
Hello,I have read the discussions that came up reg. this bug.We run 2 clusters of Cisco ACE 4710 - that is 4 devices - with software rel. A4(2.1). Uptime is 741 days and there's problems synchronizing between members, as well as the well known repor...
What is exact meaning of “Reap Conn” field in system message?2013 22:02:45 TEST: %ACE-6-302023: Teardown TCP connection 0x98d62 for vlan913:10.167.1.40/11612 (10.167.1.40/11612) to vlan316:172.18.41.205/7604 (172.17.16.19/7604) duration 0:00:02 bytes...
What is the best practice regarding interface speed and duplex issues when connecting a Cisco WAE appliance to a Nexus 7k. Should both interfaces be set to auto/auto on both devices or should the speed and duplex settings be hard coded?
Good Afternoon,You are all probably aware by now of the discontinuation of the ACE product. Needless to say after defending the ACE from vendors such as F5, it is disappointing.However, life and load balancing must go on and the question is, where ne...
Hi I have just brought ACE module back online after it lost its configurations but some ft groups have ended up in cold state after primary ACE failed to replicate the configs. I understand ft groups go into cold state when keys and certificates are ...
Hello,I'd like to ask if it's possible to configure a backup server farm with a real server in a different network than real servers in a primary server farm in bridge mode on Cisco ACE? If not, how to configure it based on the following config examp...
Hi All,Can anybody help me to know what are all the phases in https connection establishment and what would be the approximate required for each phase?Regards,Thiyagu
Hello All,Can anybody help me to know more about the command "insert-http IS_SSL header-value "ssl"?I know the above command ACE inserts a value ssl in the http header from ACE to the back end server.please throw some ideas/points to understand:1- Wh...
I have a requirement to configure WCCP on the Nexus 7K for redirection of traffic to a WAN optimiser. I have multiple sources and destination that require redirection and therefore multiple source and destination interfaces.To reduce configuration co...
Which way(s) would be the best and recommended way to software upgrade the WAE/WAVEs in remote sites?(1) push the software image to the WAE devices through CM, and reload the WAE through CM(2) copy the software image to the WAE using CLI and install ...
Hi, I'm working with my networking team trying to get our loadbalancer/failover configured. I've spent quite a bit of time pouring over the ACE documentation, and I'm still unclear on the effect of a failed probe when the probe is applied to an rse...
