Application Networking

Hello,I have a little question about these two technologies inter operability.I plan to deploy a cisco vWAAS in a cloud environnement, and i need to know if it's possible to connect the virtual appliance with a WAAS Express router like a 880 series c...

Dear Sir/Ma,Please send me the part numbers/BoM for different models for WAAS Appliance.brkuku

Hi,We have to ACE 4710 device in our network and we have facing device hung issue in our Primary ACE. We are not able to get management access or direct console access to the device when the issue is happened and also we are not able to reach the vla...

                   Hello,In the Data sheet for the WAVE 694 (along with other models) there is the Optimized TCP Connections 2,500 - 6,000.Can anyone tell me why there are two numbers and what has to change to get from the low number (2500) to the hi...

We have a WAE device that isn't using https yet https services are running on the device.  This triggered a security audit to kick it out.  is there any way to disable https services from running on a WAE device?

Hi All,Could anybody advice how would you match a url that includes = sign under an http class-map?Regards,Nilesh

Hello,We are running 4.1.5f on a 7341 attached to a 6509 using Layer 2 Mask Assign. We are getting the CIFS keepalive error:MRG-WAE-01#show alarmsCritical Alarms:----------------NoneMajor Alarms:-------------     Alarm ID             Module/Submodule...

Hello,I configured icmp inspection on the ACE module [system:Version A2(3.3) [build 3.0(0)A2(3.3)] but I'm not able to see any packets in counters with show service-policy name, all counters are empty. How would I see if icmp packet inspection is ope...

Hi,I am in the process of changing my CSS to ACE however I faced an issue. For the CSS, I am able to configure destination port and destination IP stickiness for the load balancing but Cisco ACE does not have an option for destination port stickiness...

    Hi,Anyone knows how to the load balance windows printer server (windows 2008 R2) with a pair of 4710 (Ver5.2), especially the windows print service probe setup ?           

Hi,On ace4710 I have many context and in each context there're a some class-map and I had removed two of them!Now, customer could not reach this context BUT this context is up and running and could connect to the server...====================Actually...

Hi,Configured a new context with the GUI, deployed it and the ACE reloaded and entered initial configuration mode! The peer device took over, a restore all was performed and the ACE became primary once more, the peer is now in standby cold.A show ver...

Hi All,I'm working on troubleshooting Intermittent application access. probe was getting failed intermittently.Is it possible to run any script on ACE which will do the packet capture only if the probe failed to an application?Regards,Thiyagu

Hi All,I have cisco 5020 nexus switch which is currently running with kickstart: version 4.0(0)N1(2)system:    version 4.0(0)N1(2)I want to upgrade for kickstart: version 4.2(1)N2(1)system:    version 4.2(1)N2(1)i believe it requires chain upgrade , ...