I have a Cisco Prime Infrastructure 3.8 instance running, and the links in the alarms it is sending does not contain the FQDN only the ipv4 address. In the bug tracker the only known affected version seems to be 3.1. I think it was the same before up...
Forum Posts
Hello Team, we have this Bug on our FTD 1010 and we are not able to do a workaround with other configurations.Main issue is, when we disable Portchanneling and create subinterfaces, trunk ports with VLAN Interfaces or routed ports with their own IP-A...
Team, I see the same issue on 9.12(1)2 ASA in Firepower 2130.Symptoms : Standby device is showing replication is in progress, after some time (approximately 3 hours) both are trying to become active (split brain), and services are down. This host: Pr...
i have the above system some one used your mib files to gain access to unit create a account downgrade the firmware of the sup eng wich is VS-F6K-PFC3C Serial NumberSAL1202CP8S for some reson i can no longer use the system it refuses to see gateway...
Hello. It's exactly as it looks. When i use my webcam it's fine but any other webcam than mine looks like this. I have reinstalled the program a few times but same issue. I tried my best to find other people with this problem but i just can't. This s...
calls are getting disconnected on Sent to VRU after VVB in partial service. please suggest if any fix available.
Hello, I have a Cisco ws-2960x-48tl-s switch. I am trying the iOS update from "c2960x-universalk9-mz.150-2.EX5.bin" to new versions and I getting this error:...POST: PortASIC Port Loopback Tests : BeginPOST: Failed PortPhyLoopback Packet Test asic_in...
Hello. I have a Cisco CISCO2921/K9 router with two STM1 links to two different service providers, this is used for replication from our producton site to the DR site, however, what we have noted is that the router seems not to be able to handle the f...
I installed successfully PacketTracer 7.3.1 but if i open the program, when i attempt to write my email to login in the application, it closes and the console gives me this error:/usr/local/bin/packettracer: line 8: 5158 Segmentation fault (core dump...
Still not fixed in 1.0.03.19
I dont have the RTP protocol configured anywhere in my router but am getting high CPU utilization due to NBAR, below are my top CPU processes and my router IOS version information STM1-ROUTER#sh processes cpu sortedCPU utilization for five seconds: 8...
We experienced this exact issue on a C9348GC-FXP with the following configuration:# show moduleMod Ports Module-Type Model Status--- ----- ------------------------------------- --------------------- ---------1 54 48x100/1G + 4x10G/25G + 2x40G/100G Et...
Could someone from the Cisco team please clarify with which ES version this bug got fixed for 11.6.1, if it got fixed yet.
As per bug fixes, CDP-4-DUPLEX MISMATCH issue on LAG port (Aux connected port) fixed in IOS version 8.3.150.0But in our case we have WLC3504 with 8.5.135.0 but still we are getting log on switch model WS-C3650-48PS-S and C9200L-48P-4G-E. Kindly sug...
This also affects 6.6.0.1
