Hi,
Recently some ACI Leaf-Switches did a reset reason: reset-triggered-due-to-ha-policy-of-reset
Service: fabrictrack hap resetVersion: 14.2(2f)Hardware: N9K-C9348GC-FXP
I cant understand why this is happening
I have a C930048P-E and it boots into a switch: prompt. I cannot force it into ROMMON nor can I tftp the following IOS file to the switch. switch: setBOARDID=20564IP_ADDRESS=192.168.0.1MAC_ADDR=84:8A:8D:E0:5C:80MODEL_NUM=C9300-48PMOTHERBOARD_SERIAL_N...
hi >>> The access point 702i disconnects automatically, and when I tracked the reason, the sys log appeared to me. Can you help me solve this problem? WLC model= 5508 , software ver = 8.5.182.0
Hi, we have two power supplies and on P0 we get the following messages. environmental-1-alert: v: pem out, location: p0, state: warning, reading: 13100 mv The bug recommendations have been complied with, but to no avail(IOS 15.5(3) CPLD 16.7(4r))ple...
Dears, i have a CUCM cluster running version 10.5.2.12901 and i want to upgrade on a new host with different Hostname and IP address, so i went through the procedure in cisco documents:Installation Guide for Cisco Unified Communications Manager and t...
Hi guys,We have a 3 switches stack (Cat. 9200) running IOS XE 17.6.5 with the CPU overloaded with SISF Switcher Th process :PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process433 1401525420 72375221 19364 79.83% 81.16% 82.11% 0 SISF Sw...
Hi,CSCwn38129 promised that new Roomos 11.23 will repair this issue, but the problem still exist in our case.[Mtr][Miracast] Share has to set selected when shared into Mtr call -
I'd like to point out to anyone looking at this bug, that this issue is not caused by faulty end points. It is caused by the TVS service failing to release TCP Sockets back. It is a socket leak of the TVS service itself. We have experienced this i...
Hi,There is a value we can get from the SNMPperCentCPUUtilization.Description states:This measurement may or may notreflect the overall CPU utilization of the appliance, andmay or may not be a per-process or a per-thread CPUutilization value.When we ...
As told and showed to Cisco TAC this not only happens when publishing config from SMA to SWA with admin user but also with normal ISE authenticated user account. Beside from not recognizing FTP and SOCKS Proxy mode correct, it also wrongly recognizes...
I have 2 Cat9606R, which have the same Cisco IOS XE Software, Version 17.03.05. One is working well for this command:"show bgp dampening flap-statistics", but the other got the error message. Is anyone have the same issue?
