09-19-2013 12:08 AM - edited 03-15-2019 05:54 AM
Hi,guys .
Agents become not ready after ring no answer even though i have configured the service parameter of :
Agent state after ring no answer : to be Ready always instead of the default of not ready.
Thanks in advance
09-19-2013 01:41 AM
Hi Ahmed.
Wich platform and version are you running?
THX
Regards
Carlo
Please rate all helpful posts
"The more you help the more you learn"
09-19-2013 01:50 AM
Hi Carlo.
UCS C24 M3,
UCCX :
System version: 9.0.1.10000-100.
If i make any reset or restart to the phones,will this make the agent in not ready state ?
Thanks.
09-19-2013 02:11 AM
Hi Ahmed.
No if you reset the phone yuo make the device unavailable to the CAD so it goes on disconnected mode.
restart Cisco Desktop Sync Service and Cisco Desktop Enterprise Service under uccx serviceability -->tools-->>network services
HTH
Regards
Carlo
Please rate all helpful posts
"The more you help the more you learn"
09-19-2013 02:17 AM
Hi Carlo.
I am not using CAD ,i am using ip phone agent.
09-19-2013 10:09 AM
Hi Ahmed,
Did u try restarting the PG service once.
Regards,
Ganapathi.S
09-19-2013 10:13 AM
Please keep in mind:
In an extreme situation, if there is only one agent in the Ready state, the specific call, which the lone agent did not answer previously, continues to queue to the lone agent in a recursive manner until the agent answers the call or logs out.
09-21-2013 08:36 AM
If you wait, say 5 minutes, does it come back to active? What is the Wrap-Up timer set to?
09-22-2013 11:47 AM
I am also having this issue:
But I have two queues, agent 1 in CNC1, agent 2 CNC2...
Calls come into CNC1, ring not answer... agent 1 will go to not ready. Call will then goes to CNC2... OK
So how can I set it up so that agent 1 will go back to ready state.
the problem the agent is busy and does not realize that they have been put in to not ready state.
If I change the system parm to the ring no answer to all go back to ready. then the call will never reach CNC2
thanks
using uccx 9
09-22-2013 04:08 PM
On the point - If I change the system parm to the ring no answer to all go back to ready. then the call will never reach CNC2
If the agent goes into Reserver and then Ringing and then RONAs - will this not put him on the bottom of teh Longest Idle list anyways - or you sing Most Skilled Routing?
I wonder if there is a way to disbale this in UCCE.
09-25-2013 09:31 PM
Hi,
I believe this is a default behavior to put agents into not ready. This helps the system to avoid sending subsequent calls to "Not Available" agent and to correctly calculate things like Estimate Wait Time for the Queue.
I don't think it can be overridden, still curious to know otherwise.
08-25-2014 10:31 PM
Hey guys, I had the same problem , after some researche I found the option in the system parameters check the link:
http://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified-contact-center-express/49703-agentunavail.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide