10-15-2012
09:08 PM
- last edited on
03-25-2019
07:21 PM
by
ciscomoderator
Hello
when a call arrive at the script editor, how to transfer this call to another call through gw?
the call flow is : call-- >gw-->CUCM-->CVP-->ICM(script edit)
the script editor shows below,I use the Label ,and set the number, but when the script runs, it cann't transfer to that number .
how do i transfer this incoming call to the pstn,any one can help me?
10-16-2012 02:59 AM
Hi Xia,
Please check whether the Length of the DNIS configured in CVP. The length of the label should be the same length of the DNIS configured on CVP. Say for example, if the length of the DNIS is 5 the length of the label you send from the script to CVP has to be 5. From CVP you can put a static route to the PSTN Gateway. From the gateway you can make a translation rule and convert the 5 digit number received from CVP to a complete number you require and send the call out of the Gateway
Hope this helps
Cheers,
Dass
Please rate useful posts
10-18-2012 12:25 PM
Hi Xiaosen,
You may need to use different VG to transfer the call back to PSTN. If possible please share the CVP call server logs for these type of calls.
Thanks,
Ashfaque
10-19-2012 02:49 AM
Hi Ashfaque,
It is not mandatory to have a separate VG if the existing VG has the egress feature
Thanks,
Dass
10-19-2012 09:10 AM
When you do a debug on the GW do you see the call attempting to be routed, i.e. "debug isdn q931" if you have PRI circuits?
Also, I would recommend using SIP refer transfer which will refer the call back originating routing client (i.e. GW) for transfer, simply change the label to be prefixed with "rf" and then ensure you have matching dial-peer on the GW. If by any change you use sigDigits in your deployment ensure you include the sigDigits in your dial peer.
HTH,
Chris
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide