- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-16-2014 07:37 AM - edited 03-14-2019 01:22 PM
After upgrading the Rogger to 9.0(4) and trying to log into https://localhost/cceadmin to select deployment type. The Domain field is blank and I'm getting an error: "Could not load the list of domains. Please ensure that active directory is working properly and try again."
Used the domain manager and the domain is selected. Active Directory is working.
Solved! Go to Solution.
- Labels:
-
Other Contact Center
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-16-2014 08:52 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-16-2014 08:52 AM
Try it via the AW rather than the Rogger
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-09-2014 07:28 AM
Hello lasittig1, did you end up getting past this issue?
We just upgraded UCCE to 9.0(4) and we're getting this same issue on our AW server.
Were you able to get this resolved, and if so, what did you have to do?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-09-2014 08:55 AM
I was trying to use it through the rogger and not the AW. Didn't have the issue on the Admin Workstation.
