Hi all,I have a question concerning the CP-8861(3PCC) and the use of BLF keys:I set up a key with this syntax: fnc=blf+sd;sub=<BLF_URI>;ext=$USER@$PROXY;The key does what it should: call ext 105 - but does not display the status of the ext.As other p...
Hello!I am currently purchasing and using the cbs250 model, and I would like to use the cbs250 model to perform ip multicast between peer. A node and B node performing Multicast exist, A's ip is 10.10.11.21, b's ip is 10.10.11.31. To do this, we have...
We have multiple CBS350 switches that when queried via SNMP, the switch returns an invalid IP address 0.1.134.160, along with several correct IP's. The invalid IP is the same on multiple switches at multiple clients.Walking SNMP on one of the switch...
We have this Catalyst C1200 connected to our AT&T ASEoD fiber box. The ASEoD have been setup with Vlan for Private and Public connection. Private connection to the internet is not working. We have a Grandstream GWN7660 AP on the port that has a p...
Hello everyone.I have some problem. My Cisco phone is registering in CUCM 14. I can call to other but there is problem. When it's work, first row of buttons (near screen) is lightning (green, orange, red lights). It's simmilar when phone is powering ...
Hi everyone,I’m having the following issue with my CBW150AX access points:Recently, I changed the Channel Width setting from 20MHz to Best. After that, 9 out of 11 APs successfully switched to 80MHz, as expected. However, 2 APs remain stuck on 20MHz,...
HiI am unable to access my cisco RV320 router web ui login page after adding new self-signed certificate. It says 502 Bad Gateway. The self signed certificate was created using option in RV320 router's web ui.I added the new certificate because the b...
Morning all, I'm afraid I'm stuck; this morning I came in and my Cisco Secure Endpoint client stated it was disabled. I tried rebooting and restarting the service, but no luck. When I tried restarting the service it says it can't find the file it nee...
Bonjour,Je rencontre un message de type Secure Boot sur un Cisco Catalyst C1200-48T-4G :%SecureBoot-A-board_type: Secure boot - Board detected as a DEVELOPMENT board. Images signed with a DEVELOPMENT KEY are supported on this boardInformations sur l’...
Hello, I just bought a cisco 150ax. I'm trying to start it, but it stucks on changing green -> red light in an endless loop. I called my internet provider to white list its mac address that was written on the AP. Do I need an internet connection to f...
We are approaching our latest step in relabelling posts across the Small Business board. 1 week from today, read-only mode will be active on this discussion board from June 4th - June 19th. These dates are subject to change pending progress. This ini...
