11-19-2012 03:32 AM - edited 03-16-2019 02:15 PM
Hi
We have a big issue with a incoming number, we receive 300 calls every day from the same number and it is a fax. Could someone explain me how a i can block this number???
regards
11-19-2012 03:52 AM
11-19-2012 08:18 AM
Great doc Gordon!!
Thanks
11-20-2012 02:35 AM
Hi Gordon,
I have configured your solution but doesn´t work, after configured the call come in the system. I have some doubts about your article. Could you answereed me??
6) Create a Translation Pattern ! in the ‘Filter_List’ Partition. Set the Calling Search Space to route non-blocked calls to their destination.
The ! in the ‘Filter_List’ Partition is used to route any calling party number that is not specifically defined as a blocked number . The Calling Search Space routes the call back to the phone’s partition for normal call routing
Which CSS must assign to this Translation....???
regards
11-20-2012 03:12 AM
Hi
you can block easily from the voice router . can you get into the router? if yes pls do that :
create # conf t
voice translation-rule 1
rule 1 reject / the xxx number/
!
voice translation-profile reject
translate calling 1
!
now go to the defalt dial-peer and:
dial-peer voice 1 pots
call-blok translation-profile incoming reject
incoming called-number .
direct-inward-dial
port 0/0/0:15
try that it will work fine .
11-20-2012 03:15 AM
Hi Sharon
Yes, i can get into
thanks
11-20-2012 03:51 AM
Hi Sharon,
Do your config works in MGCP registered T1/E1???
thanks
11-20-2012 04:02 AM
I am working in H323 registered E1
11-20-2012 06:19 AM
Hi Ceci,
Just to add a note to the great tips from Gordon and Sharon (+5 each )
With MGCP, you will have to block using CUCM as this cannot be done
at the gateway level. Here is one other reference;
https://supportforums.cisco.com/docs/DOC-19628
Cheers!
Rob
"And if I should fall behind
Wait for me" - Springsteen
11-22-2012 02:13 AM
Thanks Rob,
I have followed your reponse but the calls follow come in to the call-mamanger, do you know how i can see where is the issue???
regards
11-22-2012 04:56 AM
Hi
You wrote:
I am working in H323 registered E1
Finally the VG is h323 or mgcp
Regards
cc
11-23-2012 03:31 AM
Hi.
Finally the block is working follow the gordon DOC
https://supportforums.cisco.com/docs/DOC-18367
thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide