block incoming call in callmanager

[ciscoceci]

Hi

We have a big issue with a incoming number, we receive 300 calls every day from the same number and it is a fax. Could someone explain me how a i can block this number???

regards

[Gordon Ross]

https://supportforums.cisco.com/docs/DOC-18367

GTG

[ciscoceci]

Great doc Gordon!!

Thanks

[ciscoceci]

Hi Gordon,

I have configured your solution but doesn´t work, after configured the call come in the system. I have some doubts about your article. Could you answereed me??

6)      Create a Translation Pattern ! in the ‘Filter_List’ Partition. Set the Calling Search Space to route non-blocked calls to their destination.
The ! in the ‘Filter_List’ Partition is used to route any calling party number that is not specifically defined as a blocked number . The Calling Search Space routes the call back to the phone’s partition for normal call routing

Which CSS must assign to this Translation....???

regards

[sharon carasenti]

Hi

you can block easily from the voice router . can you get into the router? if yes pls do that :

create # conf t

voice translation-rule 1

rule 1 reject / the xxx number/

!

voice translation-profile reject

translate calling 1

!

now go to the defalt dial-peer and:

dial-peer voice 1 pots

call-blok translation-profile incoming reject

incoming called-number .

direct-inward-dial

port 0/0/0:15

try that it will work fine .

[ciscoceci]

Hi Sharon

Yes, i can get into

thanks

[ciscoceci]

Hi Sharon,

Do your config works in MGCP registered T1/E1???

thanks

[sharon carasenti]

I am working in H323 registered  E1

[Rob Huffman]

Hi Ceci,

Just to add a note to the great tips from Gordon and Sharon (+5 each )

With MGCP, you will have to block using CUCM as this cannot be done

at the gateway level. Here is one other reference;

https://supportforums.cisco.com/docs/DOC-19628

Cheers!

Rob

"And if I should fall behind
Wait for me" - Springsteen

[ciscoceci]

Thanks Rob,

I have followed your reponse but the calls follow come in to the call-mamanger, do you know how i can see where is the issue???

regards

[chrysostomos1980]

Hi

You wrote:

I am working in H323 registered  E1

Finally the VG is h323 or mgcp

Regards

cc

[ciscoceci]

Hi.

Finally the block is working follow the gordon DOC

https://supportforums.cisco.com/docs/DOC-18367

thanks