Command to kill Pots call on router

[vincehgov]

Hi, thanks in advance for any help you guys can give me.

We have a overhead paging system connected to our voice router on an fxo port.  Some times, users would accidentally call the paging line.  Is there a command I can use to see who is connected to the fxo port and then disconnect them?

Vince

[Anthony Holloway]

You didn't provide enough detail, but I can tell you that the command: shutdown, on your voice gateway's voice-port, will disconnect the call.

Tell us more about your setup.

Sent from Cisco Technical Support iPhone App

[vincehgov]

Hi Anthony,

Thanks for replying.

I'm running CUCM 7.1.3.  I have a Cisco 2851 router with an FXO expansion module.

Here is the config for the voice-port that my paging system is on:

voice-port 1/0/4

    connection plar 112001

!

Here is my dial-peer:

dial-peer voice 112001 pots

    destination-pattern 112001

    port 1/0/4

!

I have a route pattern configured to send 112001 to the 2851 router.  The router then routes the call out to 1/0/4.  Everything works fine.

I just need to know how to list active calls and forcefully disconnect one if needed.

[Payal Bhaduri · Accepted solution]

Hi,

The "sh call active voice brief" will show the voice ports being used.

You can do a shut under the voice ports to drop the active calls on them.

[vincehgov]

Hi Payal,

Thanks for your reply.  Is this the only way to disconnect the call?  For instance, is there a way to disconnect the call legs without shuttng down the port?

[Payal Bhaduri]

From the CLI of the router, that is the only way i can think of to disconnect calls

[vincehgov]

Ok, Thanks Payal.