cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
897
Views
0
Helpful
4
Replies

Modify alphanumeric Sip Called Number

Hi everyone,

I'm trying to set up a sip connection between ITSP and my company. When I got incoming calls from PSTN to my online number this is showing a alphanumeric called number instead numeric as below:

May 18 14:33:29.248: //11085/45231A6AA411/SIP/Call/sipSPICallInfo:

The Call Setup Information is:

Call Control Block (CCB) : 0x485ED634

State of The Call        : STATE_DEAD

TCP Sockets Used         : NO

Calling Number           : 2721048092

Called Number            : companyname01

Source IP Address (Sig  ): 10.21.18.100

Destn SIP Req Addr:Port  : 201.86.87.2:5060

Destn SIP Resp Addr:Port : 201.86.87.2:5060

Destination Name         : 201.86.87.2

May 18 14:33:29.248: //11085/45231A6AA411/SIP/Call/sipSPIMediaCallInfo:

Number of Media Streams: 1

Media Stream             : 1

Negotiated Codec         : g729r8

Negotiated Codec Bytes   : 20

Nego. Codec payload      : 18 (tx), 18 (rx)

Negotiated Dtmf-relay    : 0

Dtmf-relay Payload       : 0 (tx), 0 (rx)

Source IP Address (Media): 10.21.18.100

Source IP Port    (Media): 18952

Destn  IP Address (Media): 201.86.87.2

Destn  IP Port    (Media): 13506

Orig Destn IP Address:Port (Media): [ - ]:0

May 18 14:33:29.252: //11085/45231A6AA411/SIP/Call/sipSPICallInfo:

Disconnect Cause (CC)    : 16

Disconnect Cause (SIP)   : 500

Question is, how I will route this call once the called number is alphanumeric?

Anyone else already fixed that?

Thank you and I really appreciate any help

4 Replies 4

Gregory Garrian
Level 1
Level 1

I believe you can do URI based routing on your dial peers.  Make sure you define the URI.

How I can do that?

paolo bevilacqua
Hall of Fame
Hall of Fame

You need to ask you ITSP to send a called number.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: