07-18-2012 06:33 AM - edited 03-16-2019 12:15 PM
Hi,
When I place a call to PSTM throught a BRI port, in a CME 8 the telephone try to place that call sending only 4 digits, when I am introducing the digits, in the 4º digits stop and try to send the call.
Progress Ind i = 0x8183 - Origination address is non-ISDN
Calling Party Number i = 0x0080, '4110'
Plan:Unknown, Type:Unknown
Called Party Number i = 0x80, '630'
Plan:Unknown, Type:Unknown
Sending Complete
Jul 18 13:20:52.155: ISDN BR0/0/0 Q931: RX <- CALL_PROC pd = 8 callref = 0xC4
Channel ID i = 0x89
Exclusive, B1
Jul 18 13:20:52.175: ISDN BR0/0/0 Q931: RX <- PROGRESS pd = 8 callref = 0xC4
Cause i = 0x829F - Normal, unspecified
Progress Ind i = 0x8A81 - Call not end-to-end ISDN, may have in-band info
Progress Ind i = 0x8A88 - In-band info or appropriate now available
Jul 18 13:20:56.139: ISDN BR0/0/0 Q931: TX -> DISCONNECT pd = 8 callref = 0x44
I have checked interdigits timeout, and it is set to 5, dial-peer are correctly configurated
RouterVallecas#sh dialplan number 0630112233
Macro Exp.: 0630112233
VoiceEncapPeer210
peer type = voice, system default peer = FALSE, information type = voice,
description = `Moviles',
tag = 210, destination-pattern = `06........',
voice reg type = 0, corresponding tag = 0,
allow watch = FALSE
answer-address = `', preference=1,
CLID Restriction = None
CLID Network Number = `'
CLID Second Number sent
CLID Override RDNIS = disabled,
rtp-ssrc mux = system
source carrier-id = `', target carrier-id = `',
source trunk-group-label = `', target trunk-group-label = `',
numbering Type = `unknown'
group = 210, Admin state is up, Operation state is up,
Outbound state is up,
incoming called-number = `', connections/maximum = 0/unlimited,
DTMF Relay = disabled,
URI classes:
Destination =
huntstop = disabled,
in bound application associated: 'DEFAULT'
dial-peer voice 210 pots
description Moviles
preference 1
destination-pattern 06........
port 0/0/0
forward-digits 9
If I try to place a call to other number always is the same result, 091....... only place 4 digits, and so on.
Any idea where could be the problem?
Thanks!!
Solved! Go to Solution.
07-18-2012 06:46 AM
There is another dial-peer then.
try 'show dialplan number 0611 timeout'
07-18-2012 06:42 AM
Hi Ivan
Please show the whole configuration. Might be, that you are matching a translation rule.
Cheers
Peter
07-18-2012 06:46 AM
There is another dial-peer then.
try 'show dialplan number 0611 timeout'
07-18-2012 06:53 AM
Hi!
I just found the problem, i had a dial-peer voice with destinattion-pattern ´....´ , when i removed it, all right.
thanks everybody,
regards!!!
07-18-2012 06:56 AM
You're welcome, please remember to rate useful posts clicking on the stars below.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: