second ISDN30

[aaa5678]

I'm trying to configure the second ISDN on the same gateway but I cannot get this working.

I would be grateful if I could have some help with the configuration? I need to send the incoming traffic for both ISDNs to the call manager. The config that i havefor the  first ISDN;

controller E1 0/0/0

 pri-group timeslots 1-24 service mgcp

interface Serial0/0/0:15

 no ip address

 encapsulation hdlc

 isdn switch-type primary-net5

 isdn incoming-voice voice

 isdn bind-l3 ccm-manager

 no cdp enable

Thanks

[Aman Soi]

You can connect second ISDN to HWIC-1B-U card but it would be used for connecting to other remote/WAN site  which is on ISDN

http://www.cisco.com/c/en/us/products/collateral/interfaces-modules/high-speed-wan-interface-cards/data_sheet_c78_439537.html

regds,

aman

[kkoeper12]

Substitute your info in the commands below...

mgcp call-agent 10.1.1.11  service-type mgcp ver 0.1 (IP address of CUCM that will process calls)

mgcp dtmf-relay voip codec all mode out-of-band

ccm-manager redundant-host 10.1.1.12  (IP address of backup CUCM)

ccm-manager mgcp
ccm-manager music-on-hold

mgcp  (turn on MGCP)

Use "show ccm-manager" command to show the exact name that needs to be put in CUCM

Add MGCP gateway in CUCM under Device/Gateway.