Network Access Control

Hi,We having difficulties with installing remote agent on windows 2008 R2 64-bit server and got the attached error.Our ACS is 4.2.0.124 and remote agents we tried are :Remote-Agent-ACSse-win-v4.2.1.15-K9.zip and Acs-4.2.1.15.9-RA.zip.I see following ...

I am trying to install the same SSL certificate I have installed on my primary ACS on my secondary ACS. I have replication configured and working between the two. The primary is the ACS appliance. The secondary is windows v3.3. The problem is the...

HelloI have a Cisco ACS 5.1 virtual appliance which has been working fine, I have however just discovered that it is now unable to provide me with any logs.TACACS authentication is still working without any issues, the only problem I have is viewing ...

We currently have 2 ACS servers runing version 4.2.  These are non-Cisco servers.  How do I go about moving/rebuilding this on new and non-Cisco hardware?

Hello my friends!!!!I'm with one problem, my OS Lion don't authentication in the Secure ACS Version: 5.2.0.26.10.For the Mac Lion operating system to work you must put in execeção the MAC Address of your computer. I wonder how it could cause the OS t...

For some reason, i can't get the lobby "sponsors" to authentication to the Guest NAC server (2.0.2) using ACS 5.2 via Radius. I was able to figure out how to get the Guest NAC Radius Authentication for "Administrator" to work by adding custom Radius ...

hi,when the supplicant is missing vlan500 is open for port and everything is ok, but when supplicant has wrong configuration something happend and port is always authenticating(every 30s, vlan500 is not assign to this port with bad configuration supp...

HelloI am new to Security, currently the VPN and WIFI users are getting connection through RADIUS. Now my managment wants to change the authenticate with AD. Please advice with steps.Thanks and Regards,Shahul Hameed

Hi, I'm planning to migrate a customer from ACS 4.2 to ACS 5.3.I have migrated the configuration for all the services but I'm thinking how to configure ASA 8.4 cut-through proxy service in TACACS+.The same ASA uses TACACS+ for device mngt and RADIUS ...

Hello team:We are getting a hard time in trying to make our ACS 4.2 talk to an external FreeRadius token server. When our ACS sends the Access-Request message, our FreeRadius token server answers with an Access-Accept message with zero atributes on t...