Network Access Control

Hi All ,               I am new to wireless LAN authencation , I have about 1000 Wireless access point & 15,000 users in my enterprise network , we have 3 acs server version 3.3 ( primary ,secondary , incountry ) , Now we are upgrading this acs serve...

Hi,We are currently testing a new ACS Deployment.We are just testing TACACS authentication at the moment. We would like to map one AD Group, known as DeviceAccess1 to TACACS authentication.Now if we make our condition - SAMaccount name  = brad  and I...

I am new to ACS.What I want to do is talk to another radius server (safeword) and authenticate users against it on a linux host using pam_radius.What is the minimum steps to do this?  (setup groups/policy/users)  Using radtest, I can authenticate a l...

Hi,Just installed and finished intail setup of ACS version 5.0 Sol. engine. Next i'm not able to acces solution engine over internet explorer. Even not able to telnet port 2002.Do i need to configure anything else for enabling gui in version 5.0?Plea...

I am in the process of installing an ACS demo and tying it to AD. I have the base stuff installed meaning ACS is in and operational and I have it joined to my domain. I am now to the point of selecting my AD groups and Attributes within those groups....

Is there any requirement of installing any certificates on the ACS if authentication is performed from a SSH client.I am getting the below messages when I access from a SSH client1. Bind i/f2. Pick method list defaultand then it just fails to authent...

Hello,i would like to rename the hostname of the ACS appliance, is there anything i have to consider like problems with certificates etc.?thanks in advancedalex

Hello All,I have installed a Cisco Secure Access Control Server (ACS) with the version 4.2 and i'm using a local database to authenticate users to manage some devices that work as RADIUS clients of ACS and by safety requirements, i need to add some p...

Hi all experts .I know its a very common question but pls guide mei have created a username "Support" and want to allow him full view of running configuration and any show command he runs. But he should'nt be able to enter config mode to prevent him ...

Hello,When upgrading from Eval ACS 5.1 to permanent liceense, is it true that all data thats configured on the ACS Server will be removed from the ACS Server?Thanks

Hello,What do i need to do to set up monitoring ACS 5.1. The userguide shows that the folowing commands need to be allowed on the NAD,1.logging monitor informational2.logging origin-id ip3.logging host logging host ip transport udp port 20514—where i...