Network Access Control

Hi,We are have two syslog servers defined, however we notice that the ACS only sends the syslogs to one server and will only send to the other in a failure scenario, which is a standard operation across all platforms. However we have a requirement fo...

I want to compare ACS 5.x versus ACS Express 5.x.I cannot find a SIMPLE 1 page feature MATRIX. Does anyone know if such a document is available ?     Apart for number of devices supported etc, are there any key features missing is Express ?          ...

Hi,If you have an ACS deployment consisting of 2 or more appliances is it possible to perform a hot upgrade from V5.0 to V5.1.  Following the upgrade guide at  http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_system/5.1/installati...

Hello,We're running ACS 4.1 on two appliances that access AD as the external user database.  I've found where to specify the domain to authenticate against; is it possible to specify in ACS which of our 5 DC's to communicate with?  If so, can I speci...

It doesn't work "Launch Monitoring & Report Viewer"If i click Launch Monitoring & Report Viewer" , that 's show up " The monitoring and reports database is currently unavailable. Attempting to reconnect in 5 seconds.  If problem persists, please cont...

I'm trying to control the access of my LAN by authenticate user with EAP / MSIAS + AD.The IAS denied the access with error 112: The remote RADIUS server did not process the authentication request.I setup the IAS policy to answer with vendor specific ...

Need a help1) We have implementing 802.1x authentication( MAC authentication) for central location,each user need to be authenticate through Laptop/desktop MAC address based on 802.1x. after authenticating user have received IP address from DHCP serv...

The following error message appeared when I join the ACS to domain x.y"dns.state DNS is downJun 24 19:00:00 aaa01 adjoin[11977]: INFO  cli.adjoin Join to domain 'x.y', zone 'null' failed."DNS server is up and able to ping.Please advise how to proceed

I have a very strange problem. I set up tacacs on two Nexus 5000 switches with exactly the same tacacs, aaa config (see below). N01 is working fine but N02 has problems in Authorization. I am able to authenticate into N02 but can use only a few comma...

how to assign privilege level to a user in secure ACS TACACS+ user exist in external databaseRegards,Bilal

Hello All.Would greatly appreciate any help....We are looking at running 802.1x on the 2960 to authenticate and manage SNOM IP phones.What we want to achieve is to be done on Cisco Switch with NO Radius server but to user local authentication only.If...

Hi,I have to change ip address range of my network so what are the best practices for ACS SE 4.2 and remote agent ip address change?Will the next sequence procedure Work or i forgot something?1- change first ip address of my Active Directory where re...

When trying to login, the message appears "No radius server configured" and the local user does not authenticate. How do I access without rebooting the Switch 6500 with CatOS.

Background:Previously all our switches were running 12.2(42)SE.When a client with no 802.1x configuration plugs into the switch port the port stays unauthorized.Customer moves printer from sticky mac port (we don't use 802.1x for printers) to new bui...