Network Access Control

Hi, I have two acs 5.1. When I access through gui, both in primary instance. i want to register the other one to primary so as make it as secondary server but the problem is, it says THE SYSTEM FAILURE OCCURS: PRIMARYACS(hostname of my primary acs) U...

Dear All,I have installed a cisco nac solution in inband virtual gateway and setup active directory sso.I also configured mapping rules based on attributes from the active directory ldap server and it is workingI have several organisationnal units (c...

How can I get  Cisco Secure Services Client (SSC) ?What is the product code for the software and is it free or do we need a licence?Could you please send me If you happen to have information on how it works and known design issues with the SSC.Cheers...

Hello,I have ACS 4.2.0.124.15   installed on a windows server 2008.In the configuration menu : network config > AAA server , the AAA-server-IP-address change to 169.254.x.x each time I disconnect the  ethernet interface of the server.Allthough, the i...

I understand how to create a self-signed certificate with ACS 4.2 however....The certificates are only good for one year.  Is there a way to change this to where the certificates are good for 5 or 10 years?Thanks,Josh

Hi AllDose anyone configure cisco ACS for F5 authorisation? Do we need any specific VSA? I am facing issue, authentication is fine but authorisation not functioning.RegardsSameer Shah

Hi,While integrating ACS 5.0 with Microsoft AD i am facing error message (attached)..Can anyone help me on this??AD is reachable from ACS..ACS is behind Firewall but ACS to AD all ports are open & vice-versa.Rgds,Partha

Hi there!I'm trying to configure a Cisco ASA 5520 to authenticate SSL VPN users via either certificate or local AAA, ie, normally the user will connect with a certificate but from time to time, users may forget their card at work and I would like to ...

Hi AllWhen trying to deploy new passwords to switches via Cisco Workswe get the following error message -ERROR:RME_CDL1031:Transport session to device failed TFTP: failedCould not detect protocols running on the deviceWe can talk to said device with ...

1. Suppose we have mutliple Radius server in a Netowrk. If primary Radius server goes down , how secondary server will come into the picture..2. Where can we check ,which Radius server is active (Primary or secondary Radius server)3. Is there any lim...

Dear,I am planning to implement AAA TACAS level authentication option on my Solaris (OS) Servers. (All my servers are Sun Servers)Is Solaris supports AAA TACAS?If its not supportive any patchs or any upgrade can support the TACAS optionAny other alte...

Hi, I have a ACS Server version 4.2 and at the same time i have a Wirless Controller Device on my network.I have given only limited user access to  the Wireless Controller through ACS.The Users are configured in the ACS through which they are logging...

Hello guys,I'm seeing some unknown users in my router when I use the command SHOW USERS.    Line       User       Host(s)              Idle       Location 706 vty 0     celi    idle                 00:00:04 205.209.X.XI think they are trying to acces...