Network Access Control

Hi,I don't know how to using Ldap on acs 5.0 appliance. i need configuration example document. can anyone help me??Thanks

We have a VPN and a WiFi authentications thru an ACS @ 4.x to an external database.   Using the unknown user policy pointing to an windwos database this config works at one of our sites (main site).  The main site replicates to our backup site  but d...

I have just installed the ACS 1120 appliance with ACS 5.0. It was working fine for about a week. Now however I am getting the following error message when I try to start monitoring: The monitoring and reports database is currently unavailable. Attemp...

Wondering why my ACS 5.1.0.44.3 is showing init for NTP instead of associated.acs/admin# show runclock timezone US/Eastern!ntp server 130.126.244.44acs/admin# show ntpPrimary NTP   : 130.126.244.44synchronised to local net at stratum 11   time correc...

Hi,Here's the scenario:I'm using ACS for device Administrations (using TACACS+)I'm using the internal identity store for users.I've set user passwords to expire after x number of days (when the account will then be disabled).How does the user, when h...

Hi,Most of devices use privilege level 15 for TACACS+ administration (Extreme, Cisco...), but we have devices that require privilege level 6 in order to have admin rights (Nortel Passport 8606).So i would like to know if its possible to allow differe...

In Cisco Secure ACS 5.1 how do I change my nameserver (DNS server)?

Hi,We've currently got an ACS 4.2 appliance for wireless authentication and to increase redundancy I want to go for an additional ACS and it makes sense to go for 5.1 as it doesn't need agents and has better reporting.Users are authenticated against ...

I've looked everywhere for some documentation on how to do this.  Does anyone have a step by step on how to configure this?  I'm an ACS newbe, so please try and keep it simple.

Does this product support SNMP V2 & V3 if so how is this setup?

Hi, I have a site where everybody on the inside interface has to be authenticated by a RADIUS Server.  I have that part working but the problem is I've got a lot of AAA entries for exclude.  What I want to accomplish (if possible) is to use access-li...

Hi,I am running ACS 5.1 and having some internal users created under Users and Identity Stores.I can specify the user and password (which works fine), but I can also specify an enable password.This enable password does not work as to enter privilege ...