Network Access Control

I recently upgraded an ACS appliance 1111 from version 3.2 to 4.1.1.24. if I power up the device it asks me to reset the administrator password and all that. After the device reboots it asks me to reset the administrator password again, it keeps on d...

Can anyone tell me if Cisco has made brackets for the ACS appliance so it can be mounted in a switch rack instead of a server rack?

Dear All, i have ACS engine based on windows.in reporting , we can see its memory decrease by about 50 MB dialy.after a week it is not responding and must be restarted physically.

Hi,I would like to know how RADIUS server works. I have a PIX 501 in which I can experiment after setting up a RADIUS server. Is there any step-by-step guide (which could be followed by a newbie)for setting up a RADIUS server?

Hi Experts,I am trying to configure/change the IP address of the ACS appliance through console port but the problem is that it is not allowing me to do when it is up and running hence i restarted it and went to bios diagnostic msgs after ACS boots up...

I am trying to find the serial number of an existing ACS installation.Does anyone know where the licence key is stored within the configuration files/registry ? Thanks

We currently run ACS 3.3 on a member server. We authenticate users to AD groups for Wireless and Network Management of hardware Devices. We upgrading to ACS version 4.2 on new hardware. From discussion on this forum it looks like we can run Windows S...

I installed ACS 4.2,ANYTIME I try to login to the router it ask me the enable password and give autho failed in the acs log,can somebody help pls. sample of the configuration I put in the Router:

Hi All, Any idea? After clean up all routers and switches config files, sw3 still asks for radius username and password. When console login and using 3550 password recovery procedure, it still asks for username and password. When config aaa new-model...

Failed to authenticate on test account

aaa new-model!!aaa group server radius cisco-acs server-private 10.32.108.68 auth-port 1645 acct-port 1646 key u14c server-private 10.32.0.9 auth-port 1812 acct-port 1813 key u14 ip radius source-interface BVI1!aaa authentication login default group ...