Network Access Control

Hi I have the following issue, user exists on both the ACS and token server authenication is set to external database with no unknown user policy as the user is known to the ACS! this fails authenication error message is CS user unknown... Now if the...

Hi -We have ACS integrated with AD and when a user is dynamically mapped, we would like to change the group locally on the ACS from what the mapping was, but after a while, the user changes back to "dynamic mapping" and the old group.Is the only way ...

Hi,Can someone explain the issue below to me. *Jul 15 16:40:16.677: TPLUS(0000023C)/0/WRITE: wrote entire 21 bytes request*Jul 15 16:40:16.781: TPLUS(0000023C)/0/READ: socket event 1*Jul 15 16:40:16.781: TPLUS(0000023C)/0/READ: read entire 12 header ...

Hi All,I have a pair of ACS 1113 appliances with replication configured. I'm authenticating against a pair of AD domain controllers with the Remote Authentication Agent installed. The Primary ACS appliance has no problem authenticating against eith...

hii want to upgrade the acs(windows) from 4.1.1 to 4.1.4 or 4.2 there is 1 document i know ... it says---------------------------------ACS 4.1.1.23 or ACS 4.1.1.24 to ACS 4.1.3 or ACS 4.1.can upgrade from ACS 4.1.1.23, 4.1.1.24, to ACS 4.1.3 or 4.1.4...

Hello, I am trying to configure 802.1x on our network. I am running into an issue. When the PC without a certificate is connected to the IP Phone, upon the authentication failure the switch does not assign the port to Guest or auth-failed vlan. so I ...

Hi,Recently we installed the Cisco ACS 4.2 ver in our network and we are adding the network devices to it. now all the network devices are working with TACACS+ id's except the secuirty device like pix firewallsexisting pix configuration...Cisco PIX F...

Hi All,I've got an issue when adding a device to ACS.When I try to login to the device after adding it to the ACS, it does'nt prompt me to enter my tacacs username and password, instead it prompts me to enter the tacacs username/password details when...

hi,we want to implement the TACACS on the security deviceslike PIX & ASA.Can some body pls send me the command set that i have to place in PIX & ASA.these devices use both CLI & PDM & ASDM.another requirement is once its configuration done i have giv...

Hi, i am using ACS 1113 Hardware platform,unfortunately i lost the username and password ,for it can i get ACS 4.0 recovery CD? in cisco.com i found only Recovery CD for 3.2 version will it serve the purpose?

i have AAA server , when i configure tacacs authentication on edge switch , no response from AAA to the edge switch , but for radius configuration it is working