Network Access Control

I have configured the pix firewall for ACS authentication and command authorization, everything is working fineaaa-server TACACS+ protocol tacacs+ aaa-server TACACS+ (inside) host 172.28.x.x x.x.x aaa-server TACACS+ (inside) host 172.28.x. xx aaa aut...

I have pix 535, i want to configure it for ACS authentication, but problem is that, users tries to login from inside interface and ACS located on outside interface of pix firewall. I have configured the following commands but still not able to get th...

I have configure Cisco ACS v4.1 to control network accessing. When a domain user logon, it takes a few seconds to logon and map the network drive if it is conencting to a port without configued autnetication. However, it takes around 30 seconds to 1 ...

i m not able to configure the command authorization. I obey the pattern that u send on the fourm, I did the same but still not getting user is able to do all the tasks. i made a command authorization set as mentioned with show and deny it with unmatc...

In the current situation, IP phone authentication is done using ACS local DB.What we want to do is forwarding devicename & paswd through our ACS to an external DB (Windows, ldap or other). Do I need to create an av-pair in IOS-radius, VSA 26 which co...

For a free white paper on how to manage your ACS server with a view to meeting auditory reporting requirements such as SOX/COBIT please take a look at our white paper here:http://www.extraxi.com/audit.htm

Can I setup NIC teaming in the ACS 1113 Solution Engine? It has two NICs, NIC1 and NIC2, the manual has me using NIC1.

I'm having a little trouble configuring AAA to allow the two levels of authentication (User and Privilege) between two seperate groups (default and XAUTH). What I'd like to accomplish is this:default (or defined group, doesn't matter):- use line pass...

I am not able to configure the enable mode authentication, I have set the ACS user password in Tacac+option tab.and configure the device for enable mode authenticationaaa new-modelaaa authentication login default group tacacs+ localaaa authentication...

Hi,I am facing problem with ACS 4.1 accounting, TACAS+ Accounting and Logged in Users report are not working, the csv file is been generated but nothing is showened in the file.I have checked the documents related to ACS 4.1, it says that there is a ...

I'm having difficulty logging in to a Catalyst4948 Switch via putty with RADIUS authentication. The VTY and console lines are set for transport in ssh. I can login via the console port and authenticate with the RADIUS server. I get an authentication ...