Network Access Control

Hi,I use an ACS 3.3 and simply want to delete lot of user (~860) from the Cisco Secure Database. Is there a solution to delete all users from a group? I've not found this option. Thank you for your answer.

I have Cisco Secure ACS Solution Engine v3.3.I have configured it to authenticate users agains Microsoft Active Directory Windows 2003. In The server i have installed Remote Agent.In Reports and Activity i can see Passed Authenticactions, but when th...

We are currently using our ACS to authenticate router/switch access using TACACS+, VPN with RADIUS and 802.1x port authentication using RADIUS My question is what is the best way to keep these user groups seperate so a VPN user cant gain access local...

Folks, We have a strange problem, when troubleshooting , many people from are support team telnet into the same router. and they do not know if anyone else is also telneted into the router.Is it possible to restrict only 1 telnet session into a route...

I am trying to configure a simple authentication using WinXP(MD5) to ACS v3.3, I have configured my 3550 and ACS according to the documentation but I recieve the following error message on the ACS :Invalid message authenticator in EAP request. Any he...

Currently piloting wired 802.1x using Cisco ACS 3.3 for RADIUS, Catalyst switches, and 2000/XP/OSX built-in 802.1x supplicants.Built 2 ACS servers for redundancy, but notice when I down the "primary" server, ports do not get authorized as quickly as ...

I want to achieve a simple authentication process. When a user wants to access the internet, he/she would have to enter username/password combination. The platform is 1721 or 1841 router.I tried to use authentication-proxy, but it turns out IOS 12.3 ...

I am looking for the MIB of the Secure ACS Appliance could someone send me a link where I can find it.thanks

Hi,I have recently been getting more involved in the PIX firewall and Cisco ACS server used by our company - however, my experience in these fields is pretty limited.One question I have is - on the ACS, I can view "logged-in Users" reports. We also h...

Has anyone setup an ACS Server 3.2 for MAC authentication using Windows as the authentication. The documentation I found shows how to set it up using the CiscoSecure database. Any help would be appreciated.

Hi,I have a Cisco ACS -2511 with 3.3 ver installed. I need to change the Ip address of the box.It says the ipaddress cannot be changed through HTTP.It is also not allowing me to connect through console nor to telnet into the box.Does anyone know the ...

Hello,Could someone explain how to clean disabled accounts from ACS v3.3 database, if there is more than 1000 disabled accounts?Juris

I am trying to configure Cisco ACS as an authentication server to the CAS. Can someone tell me what parameters I need to enter in to the CAS as well as the ACS?What do I enter for the:1. Server-Port2. Radius Type 3. NAS-Port4. NAS-Identifier5. NAS-Po...

I have installed Cisco ACS 3.3 on a Windows 2003 member server. This server is not a controller (domain controller or otherwise), I am told it is just a "member" server.I am told the directory is a 2003 directory by the server guys. I'm not sure if t...

Hello,My issue is as follows:Environment: Cisco VPN Client Rel 4.0 on my Windows 2000 OS(Using Dell Inspiron 2650). Transport tunneling is enabled and using IPSec over UDP. WINS tab is updated with some IPs to connect to our mail servers. Group VPN a...