Network Access Control

HiI was wondering whether it is possible to obtain dialout numbers for DDR routing from a RADIUS server rather than them being stored in the configuration on the router??I have a 3745 with a PRI card centrally, and a number of 1721's with BRI cards a...

Currently using ACS for Win pointing to external Windows NT domain database. PIX is setup to authenticate VPN clients and authenticate outbound http access to this same ACS. Working ok but while I want all inside users to be able to browse the Inte...

I created two groups on ACS 3.1. One is for wireless user ,another group is used for VPN client. I found that when I try to use VPN servece,I can also login with user ID belongs to wireless group and vice versa.How can I isolate the user id of two...

I am running ACS version 3 and have several routers around the network.I currently have it setup so tacacs is enabled and when you telnet or console into one of the routers it asks for a username and password, If the user who logins is authorised for...

We have a stub network that we want to install behind a pix 501. We would like to make any inbound traffic coming from that subnet to be authenticated against our Cisco ACS server. Is this possible? How do I do it?Stub-a --- Stub RTR --- Pix501 -- RT...

I have a Windows 2000 server , I would like to install ACS 2.4.1 on it ( since I have the software ) Since W2000 is based on NT tech will this work ??

ACS version 3.2 running on the ACS appliance. I want a user to be able to TACACS into a router and run 'reload' only. I've set this user up with these parameters1. Under 'Define max Privilege on a per network device group basis' I assign level 15 ...

How do you configure pix to authenticate locally when using console and Radius on ssh. The problem we are having is if we enable Radius authentication, it tries to authenticate the enable password on the IAS when we console in. If we set to local, it...

I could telnet in to my Cisco 2620 using RADIUS authentication "telnet 192.168.4.10 2033" (provide username/pass)and then type AT which My modem reply with OK.I could also dial-in to the NAS with local userBut I could not dial-in using RADIUS user.Pl...

Is it possible on ACS 3.2 appliance to generate a dynamic WEB Key? If YES, what is the procedure? If NO, what is needed to generate it to secure my wireless LAN?

Hi there, May I ask that does ACS3.1 and ACS 3.2 support Win2003?thanks a lotDavid

Can anyone suggest how I can restrict access using ACS TACACS+ to a destination port or IP Address? I restrict access by group. Each group has specific access to DMZ's on the NDG's that authorize through the ACS. Any ideas?

I have acs sever for windows 3.2 . i want to know if this prouduct can operate with cisco router 803 or not ? thanks

CiscoSecure ACS 3.2 - I want to give selected users:- unlimited access to all CLI command set- enable access but only to selected commandsI'd prefer not to have to visit each router but do want the same control if the TACACS system is unavailable

i have many accounts on my ACS V3.2,which is on win 2k server,the authentication is using domain.some users are complaining that they cannot connect but some users can connect the same time.when i receive the call i usually connect from my home and s...