Network Access Control

I'm trying to configure our ACS 3.x server to use Generic LDAP. I'm getting this error in the failed attempts report " External DB reports error condition"Can anyone offer help on how to troubleshoot from that error message? Is there a way to log wha...

hi allplz try to understand the following1 cisco 3600 series router1 ethernet port to local lan i.e:3500 series switchi am trying to connect a L3 switch to one of the router eth ports whereas i have a machiene on the 3500 series switch mentioned earl...

Recently we purchased the Cisco ACS server 3.2.X Can we install the ACS server 3.2.X on a Windows 2003 server?

Hello all, Is it possible to use Catalyst 2950 switches as Agent hosts for RSA Securid tokens ?I have been asked to investigate Securid authentication for LAN users and I need a device which all pc's pass through to act as an agent host and redirect ...

We already have the Windows ACS engine configured & working. We want a backup but need to know if the Appliance can synchronize with the windows engine. This is mainly an attempt to ensure that a windows worm can't take down our whole ACS system.Than...

Is that possible for the VPN client to get same permanent IP address and specific ACL policy each time they access the network via VPN Tunnel and authenthicated by ACS server. In another word can ACS server push a particular IP and policy for each cl...

Hello all,I need to perform a per-user NAT translation and can't figure out if this can be accomplished with PIX and ACS :When an authenticated user gets access to my inside network, I need to perform NAT to assign each one an specified IP address, m...

I use Cisco ACS for Radius AAA to remote access users. The radius accounting logs have the columns Acct-Input-Octets, Acct-Output-Octets, Acct-Input-Packets, and Acct-Output-Packet. I found documentation explaining these fields but nothing on the val...

I am aware that the ACS on Windows has the CSUtil.exe utility to achieve bulk importing of aaa clients(ADD_NAS statements). But is there an equivalent tool/feature with the ACS Solution Engine to achieve this. I expect that most installations would h...

we have include this vsa for Nortel switches: [User Defined Vendor]Name=Nortel_EAPIETF Code=0562VSA 1=Port-PriorityVSA 110=NtnStringNameValPair[Port-Priority]Type=INTEGERProfile=OUTEnums=p-values[NtnStringNameValPair]Type=STRINGProfile=MULTI OUT[p-va...

When attempting to map groups on existing W2K domain keep receiving error message "Failed to enumerate Windows Groups". Current login is at highest level on ACS appliance and domain can be seen but groups still not coming up when mapping is attempted...

Hi,UCP ( User changable password ) doesn't work for username's containing "&" character.Although user can login but can't change the password. From UCP utility point of view , is there any restriction on using special charachers in creating users ?

I have an ACS 3.2.3 server, trying to get authorization working. I have 2 device groups and 2 user groups. I want user group 1 to have full enable access to both device groups, but user group 2 to have only enable access to device group 2. User group...