Network Access Control

Cisco Access Control Server (ACS), Identity Services Engine (ISE), Zero Trust Workplace
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

Labels

Forum Posts

I have config this config for ssh on a Cisco routerline vty 0 4login localtransport input sshBut when I run the show ssh I got following output%No SSHv2 server connections running.I'm happy for any suggestions, thanks 

Dr Evil by Level 1
  • 3440 Views
  • 2 replies
  • 0 Helpful votes

Team,I have 2 questions on the ISE: 1. When we talk about “GigabitEthernet 0”, which port does it map to on the ISE 3515 diagram below.    Is it port number 4? And then what about “GigabitEthernet 1”?    Please refer to the below diagram:       2. Ca...

Cisco ISE.jpg

Resolved! Java in ISE

Hi, A customer of ours has asked if we use Java in ISE. If Java use is version dependent, this customer runs ISE 2.4. Any guidance?Thanks. Best. Kurt

kradecki by Cisco Employee
  • 2057 Views
  • 1 replies
  • 0 Helpful votes

The SNS-3695 is built with 8x 600 GB 10k hard drives, and for a PSN I feel that is fine. Has there been any thought put in to offering an option to replace these drives with SSD's?  The primary use case I have in mind is for the monitoring nodes.  Si...

    Hi Everyone,    I have a question since I am deploying 802.1x port based security feature on CAT 29600 and following is the existing config with port-security enabled on the interface. Can I configure  multi-auth for host mode on the interface ? ...

rajulpar by Cisco Employee
  • 3555 Views
  • 4 replies
  • 0 Helpful votes

Hello,   This is regarding posture polcies in SDA environment, DO we need to create a seperate SGT for unknown posture, and restrict access using trustsec policies or the Non SDA approach would still work i.e restricting the access using DACL's.

hsangral by Cisco Employee
  • 1669 Views
  • 3 replies
  • 0 Helpful votes

  Hello, Can anyone please unicast me if the new ISE Base license is calculated based on the qty/nr of endpoints or network type ( wired / wireless)   Customer has 100 Wireless endpoints and 200 wired endpoints   Q: How many licenses are required 300...

crprunoi by Cisco Employee
  • 1151 Views
  • 5 replies
  • 0 Helpful votes

We recently upgraded from 1.3 (no nmap probe option available) to 2.1 (defaults to policy nodes having nmap probe enabled). Long story short - it's profiled a bunch of our devices improperly as cisco-router. Xerox & Ricoh printers, some apple devices...

Y C by Level 1
  • 775 Views
  • 4 replies
  • 0 Helpful votes