We operate several public-facing websites similar to spellbees.us and wafflewordgame.org, where maintaining fast response times and high availability is critical to the user experience. As traffic continues to grow, we want to proactively monitor the...
Forum Posts
I'm looking for some advice from other enterprise network teams.At my organization we use Cisco DNA, Splunk, but our access and licensing are fairly limited, so we're looking at other options that can provide better network visibility and operationa...
Having a little trouble creating an admin user on one of two Nexus9k's running nx-os 9.2.3. Works fine on one and not the other. I've compared the configs and don't see any difference related to this.When I type the following: username newadminname p...
Trying to figure this one out, I have 2 WAN and 1 backup WAN connection. I want 2 WANs always active for specific Routing and load balancing. I want my backup connection to be just that in case the Main WANS go offline. I am using port 3 and port 4 f...
Resolved! SNMP at 5s and 6s
Hi There,Was wondering if someone has come across this before.I'm polling a couple very limited SNMP OIDs (ifHCInOctets/ifHCOutOctets of some interfaces) at high intervals on Catalyst 9300 class switches.At 5s, the ifHCInOctets/ifHCOutOctets is very ...
Has anyone successfully connected to their Cisco Modeling Labs with Claude via MCP?My Claude Desktop shows the connector with all permissions available, but my Claude Desktop does not have access for some reason.I have a feeling I’m missing something...
Dear community,I am working with Cisco 1300 series switches and would like to configure RADIUS authentication and authorisation for SSH administration.RADIUS authentication is working correctly, but after login the user is assigned the minimum EXEC p...
Hello everyone,I'm currently continuing my Extended ACL lab, and I have a question.How can I allow a specific IP address within a VLAN 30 (IP address: 192.168.30.10) to access another VLAN without allowing that other VLAN to access the specific IP in...
EnvironmentWe encountered this issue while migrating network devices from SNMPv2c to SNMPv3 for monitoring.The problem was observed on multiple Cisco Catalyst platforms, including:Catalyst 2960Catalyst 2960SCatalyst 2960XCatalyst 3750Catalyst 9200Cat...
The Day the Clocks Went BackwardsExecutive SummaryOn 8th July 2026, a failure in a time-synchronisation system contributed to a major nationwide disruption across Telstra's mobile network. The incident was not initially attributed to a cyberattack o...
Can someone please explain what BGP is (for beginners).
Resolved! RJ45 Roll Over Cable for C1300-8P-E-2G?
Hi,I am trying to confirm which roll over cable will interface with the Cisco C1300-8P-E-2G network switch? I am looking for USB-A on one end and RJ45 on the other to the C1300. I am having trouble finding information regarding these cables on the ...
# Cisco Secure Client 5.1 – Always On VPN disconnects when connecting to a Wi-Fi Direct printer while the LTE connection remains activeI'm investigating what appears to be an interface selection issue in Cisco Secure Client 5.1 and would like to know...
I have a couple of IE1000 (Version1.9.3) switches, and I want to enable LLDP on them. However, I cannot find any option to enable LLDP in the web GUI or through the command line.
Hi ,Just noticed a new Early Access program for Meraki : Couldn't find documentation. I'll update my post when I find more information about this.
