Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

Hi Joseph,I am configured email notification for alerts & events in DFM, I do receive email notifications for alerts/event when they are activebut i do not receive any email even when the event is shown cleared in DFM. Whereas i have already checked ...

xs.gautam by Level 1
  • 969 Views
  • 2 replies
  • 0 Helpful votes

I am using LMS 3.2 and Device Discovery never finishes. It discoevers the majority of devices and then hangs. The only way to stop it is to run pdterm CSDiscovery from the server command line. I used to have exactly this problem under LMS 3.1 and was...

mburrell5 by Level 1
  • 1065 Views
  • 4 replies
  • 0 Helpful votes

Using LMS 3.2, there is an issue with Application Registration.Campus manager 5.2.1 is installed but when viewed in Application Registration Status it says Campus manager 5.2. When new devices are dicovered by Campus Manager it sets the version as 5....

mburrell5 by Level 1
  • 666 Views
  • 2 replies
  • 0 Helpful votes

Can some one help me figure out how to track down this rogue device on the network. I noticed it in my Kiwi Syslog  server. It shows a hostname of 10.0.0.7. I can ping it, but I cannot seem to locate it. I have tried using Nmap with the following res...

Hi ppl,I have a problem with my LMS 3.1, when I try to setup a Statistics Collection on Ethernet Ports in CiscoView mini-RMON Manager a Error Message Appears.... it is "Failed to Enable Statics Collection!" I tried... Verifying access, SNMP credentia...

Review Cisco Networking for a $25 gift card