Network Management

Can I install CWLMS-3.0-1.5k-k9 onSUNW,Sun-Fire-280R SUNW,UltraSPARC-III+I'm currently running LMS2.6 on this box.Do I really have to have SUNW,Sun-Fire-v440?

I am looking at setting SSL VPN for roughly 1000 users and need a throughput of 1Gbps. It looks like the ASA 5540 will support my the number of users but the will lack on throughput. However, the ASA5580 will support both requirements but it is an ov...

Hi All,I need to know if there's a traffic generator that allows me to manipulate the payload size of the packet. The ones I've seen on the Internet are like ''Traffic'' which works only with bytes and is not that good.I need it to test the efficienc...

A number of switches have this entry for VLAN config:Couldnot create file in /tftpboot directory. VLAN Config fetch is not supported using SCP. VLAN Config fetch is not supported using TFTP. Is this because /tftpboot is 777 but owned by casuser:casus...

Hey I'm getting into switch and routers stuff, and I wonder if there is some way to know how many routers, switches or hubs are between 2 pc (server - workstation) in a given LAN, including hardware information like mac -addres 'casue I'm trying to f...

Hello, does the IPM of the LMS 2.6 use the timestamp with the hour GMT?

Hello,I use IE7.0 and I configured registry for possibility to launch telnet from Topology map. But when I click on device and when I choose telnet - the new window is displayed, but with the message "The webpage cannot be displayed" (see the attachm...

Hello,can u tell me if cisco router has some posibilities to generate traffic statistics. I want to know per IP what websites have been visited and what other traffic have been made from that IP.Thanks a lot!

Hello,When I try to download soft from LMS to device, it start (!!!!!.!!!....) and after approximately 1 Mg , it stops with a timeout error.(%error reading tftp://add_lms/rep-softxx (timeout))I use LMS 3.1 with a virtual plateform ESX.Is there any s...

Hi, I am facing issue with DFM when I try to put the threshold for device in DFM I can not see devices in DFM...particularly when I try to set thresold ...but on the home page of DFM I can see all the devices in Known state..any idea why its happenin...

To increase production windows, we are thinking of having two servers A1 and A2. Where A1 is accessed by users through address A and ETL is accessing server A2 through B. Once ETL has finished, we wish to swap the addresses such that A points to A2 a...

Dear Folks, I would like to know whether LMS could discover WiSM and lightweight access points.Could you tell me where can I get the documents for these for discovery of WiSM and LWAPP's ? Regards,SID

Hi I am seeing one problem in LMS. I can see 52 devices in RME & CS. But when i go to topology view & can see only 51 devices... If i go to CM-->Visualization then I can see only 52 devices in RME, CAMPUS & I dont see a single device in DFM & CS..y i...