Network Management

Hi, I am in the process of learning SNMP and setting it up on a 3750X switch stack I have. I was hoping I could get a clear definition of the differences between SNMP READ access and SNMP WRITE access when granting a monitoring software access to the...

Hello, I'm hoping this is the right place to make this post, if not please recommend a better discussion area/group.I was looking at trying to use the CCP software from a Windows XP and/or Windows 7 machine to connect to a 4331 router but it returns ...

Hello, Can any one send me exact OIDs for monitoring PSU voltages, Current, CPU Load, Memory and Temperature for ASR1001 Router.I tried following MIbs from CISCO's ftp site but no luck.CISCO-ENVMON-MIBCISCO-SMI-MIBCISCO-ENTITY-SENSOR-MIBENTITY-MIB

Hi, strange problem here. Im trying to deploy a config through Cisco Prime Infrastructure 2.2 on a couple of Nexus devices. It all looks good until i try to do this on Nexus 5548 where i get this error:   Error occured while executing the command t...

heyi can't see any cpu utilization and memory utilization   on my WS-C4948-10GE and  WS-C3650-24TD, both is completed in last inventory collection statuswe have WS-C3650-48PS that is working perfect with cpu monitoring and ramwhen i go in the device ...

2015-03-31 11:17:31        Local4.Error        192.168.X.X         Mar 31 2015 09:53:29: %PIX-3-305005: No translation group found for icmp src ICS-GTECH:10.3.X.X dst ICS:192.168.X.X (type 8, code 0)

I can not select any Device or Device Group or Port Group under: Monitor -> Monitoring Policies -> My Policies -> Add -> Inferface Health (policy type) -> Device Selection  "Device Selection" gives me a empty white screen! Any Ideas?

I have installed Cisco prime infrastructure 2.2 and configured it.Now i want Per switch Per vlan traffic and per switch per vlan sessionfor that what i have to do please suggest me as soon as possible Switches is 2960 and 3750X. Please suggest me and...

Hello Community,Can someone please let me know why the following script with ping size 1000 and repeat 1000 won't work, however ping 100 and size 100 will work. event manager applet test11 event none action 010 cli command "enable" action 020 cli com...

I am trying to generate a trap based on sla breach on a IOS XE router.  What MIB could I use?Here is the config from the router: track 1 ip sla 1 reachabilityip sla 1icmp-echo 50.232.60.177 source-interface GigabitEthernet0/0/3ip sla schedule 1 life ...