Hello, I'm very limited in my knowledge of Cisco systems but was wondering if it is possible to setup a cctv ip network to present its images to the recording server in the best available speed and quailty with minimum lag time. I have all ip cctv ca...
2950s work fine when upgrading the IOS using CNA. On all 2960s I get Failed to execute the command archive download-sw /overwrite /http iosFileIf I run the command using telnet and tftp server it works fine.I have tried by deleting the old image then...
Because Prime or LMS has no ability to backup FWSM and ASASM configurations, here I share our trick to do "backups" from a remote linux server.FAckup.sh stands for FWSM-and-ASASM-backup :-) It uses ASDM stuffs to get configs.Configuration file looks ...
Just got my PI 2.0 upgraded to 2.1 I was reading through the release notes and was wondering if PI 2.1 can be used with a 5508 running 7.6.120.0 code. Currently we are running 7.4.100.60 and haven't put any new code on due to PI requirements. Same ...
Hi I am looking to test SDN and Open flow capabilitties within a virtual enviorment e.g GNS3 - is this possible and if so what code will support this Many thanks
I have CiscoWorks LMS 3.2. Our Network has changed drastically and I want to get rid of everything and do a re-discovery with only certain subnets, most of them being a /23. Does anyone know the best procedure to accomplish this?Thanks in advance!
I've been using THIS, which Joe has modified. The script checks the CDP table and only works on routers, switches and wireless access points. The problem is that the access point doesn't seem to work. Here's Joe's script:
event manager applet...
Hi everyone.We are a little concerned about many high peaks regarding CPU utilization on a Cisco Nexus 7k (version 6.2(2)). Peaks often reach 100%. Here's the behavior:# show processes cpu history ...
Hello community, I'm currently working on a C819HG-4G-K9 (version 15.2(4)M4) router and I've encountered some problems when using SNMP for getting the values of some parameters, like the RSSI.For this device, the SNMP Object Navigator tool indicates ...
We would like to graph some counters from a service policy that is applied to an interface. How do i find the correct OID to read with my snmp tooling? See below red variables.I found that it should be somewhere below the .1.3.6.1.4.1.9.9.166.1. tre...
Hello, I am having a issue pulling configs from Cisco ASAs (5520s and 5540s) using Cisco Prime 4.1. When I do a Reachable Status it passes SSHv2, but when I check the Sync Archive job I get this error....CM0151 PRIMARY RUNNING Config fetch failed for...
Hello Cisco!I've been playing around with EEMs on and off for a few months now, and I'm enjoying it quite a bit! A recent issue at work got me thinking, and I thought I'd try and solve the problem with a new EEM. It's really quite simple, but I'm hav...
