cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
331
Views
0
Helpful
0
Replies
Highlighted
Beginner

Need help for multicast configuration

Hello Friends,

I have an issue with receiving multicast for a new connectivity. Its used to receive data feeds from for financial data providers for test/uat environment.

Background:

On Cisco router Mcast routing is already enabled; there are few connections already working here and can see mroutes for the working connections. PIM adjacency is built using GRE tunnels over IPSec VPN. 

Issue:

I have set up a new tunnel to our partner network. IPSec & GRE tunnels (int tun 60) are working; enabled PIM-SM on GRE interface, added static route/mroute for the mcast sources and ip pim rp-address with ACL.

Now, when I add static route for the RP - it impacts the existing mroutes. 

Symptoms/indications observed:

Upon adding the route for RP, the output of "sh ip mroute" for the all working mroutes displays RPF neighbor and RP as Tunnel60; and the existing connections fail.

I have verified that the new new connection RP doesn't correlate / conflict with any existing connections.

 

Thanks in advance for your help.

Krishna

0 REPLIES 0
Content for Community-Ad