Network Security

Hello, I acquired an old Cisco 506e firewall and it has an enable password set on it. The firewall used to be in a production environment where I work, but has been sitting on the shelf for several years. I wanted to get some hands on practice with f...

Hello, I'm facing a problem that cisco ASA 5506-X doesn't get the user logged ip address,  regards

Hello, I've been working on implementing a Zone Based Firewall for our offsite users that utilize an 881 router with DMVPN tunnels to connect. Right now I have an outsize zone (WAN facing), inside zone (LAN) and the self zone. I have zone pairs for I...

Hello Cisco Community, I would like to know what kind of training we need to have to learn the linux of (ACS, ISE and Sourcefire)? Thanks in Advance.

Hi I have a ASA 5545 with version 9.4(2)11 in routed mode And I have problems with the Global ACL. I started with ACL's on the interfaces and that works fine. I put an ACL's on the interfaces with the lowest security and I use the ASA default that tr...

We are looking at replacing our old Cisco ASA firewalls with the ASA 5545X with firepower IPS, URL and AMP in a active/standby configuration. I have attached our topology, which is HQ and three remote sites. All servers and network resources (includi...

I purchased a Cisco 5506 - x on Amazon and I am now looking for a certified partner so I am able to download my patches. I have contacted 3 in my area and they are not familiar with what to do with a ASA that has been purchased from Amazon. I find it...

I have a Firesight Management Console VM that has been running fine for a couple of months. I tried to log in today and got the following error: "Unable to authorize access. If you continue to have difficulty accessing this device, please contact the...

Have a client who only had provision for single IP address on the outside interface. Now they have had a another /29 subnet as they needs have increase. The current outside IP has 4 L2L VPN and 9 DNS entries , so instead of have to rekey all the chan...

I have a firewall DOD DISA STIG I need to apply. I have to set authentication timeout to 60 seconds. Is there a way to set authentication timeouts? So if a user tries to SSH into the device and let it sit at the login screen for 60 seconds, reset/dro...

Currently I'm able to limit bandwidth for the whole subnet like this: I want to have a limit of 2Mb down 1Mb up for each client not the whole subnet. Yes I could create two access-lists and class maps for every single IP in the range, but I don't fee...