Hello,
Does ASA support MLAG. I am checking recently connection between ASA to switch via Etherchannel and find a terms of MLAG. Could you please advise?
Thanks!
Hi All,
One of our client requested to allow one url hosted in internet. Destination ips are too many but at a time only one will be in working state,they keep changing the destination ips in a short time interval. Is there any solution is available ...
Hi ;
i have 2 interface in my cisco ASA Version 9.1(1)
interface GigabitEthernet0/0
description Internet Circuit
nameif Internet
security-level 0
ip address X.X.X.X 255.255.255.252
interface GigabitEthernet0/1
description DATA VLAN
nameif DATA-LA...
Hello,
I recently discovered an older tool to assist in blocking malicious IP addresses. It seems the tool is no longer available. I was looking for a similar tool. I tried to download it, but to no avail. The open source tool is called blocklist2ac...
Morning / Afternoon
I have an ASA 5508 that at present seems to be working on the whole ok, up until I added a new network to one of the spare interfaces.
Directly attached to the ASA is the;
'Outside Interface' - connected directly to our ISPs route...
Hello All,
If i am trying to access FW separated server and im getting reset packet on FW, who generates it.
As in destination server generates the reset packet or FW itself generates it.
I'm looking for configuration instructions for an ASA 5505 to allow me to connect my iPhone using the Cisco AnyConnect Secure Mobility Client.Anyone know where I can get step-by-step instructions?I have an ASA 5505 with O/S 8.2(3) and ADSM 6.3(4). Th...
Hello,
I'm looking to upgrade my ASA 5510 to the latest version. I am currently running on version 8.4(2) of the software.
Can anyone give advice about the upgrade path that I should take?
Thanks.
Had this problem today with ASA 5516-X on ASA v9.5.2-14. Essentially the firewall stopped forwarding all between connected interfaces/subnets. From the firewall console, I could ping pretty much anything in the network and on the internet. But fro...
How do I use IP ranges in ASA firepower ASDM ?
Individual addresses work like 192.168.1.100/32Full subnets also work like 192.168.1.0/24
But I cannot seem to find a way to use IP ranges in network --> individual objects.I tried something like 192.168...
Hi,
I got my 5506-x up and running and need to apply the license to the fpower module.
My device came with a big white envelope and contains a software serial number sticker on the front of it, and the contents inside the envelope contain (1) piece o...
Hi,
I have a Cisco ASA which is the gateway for all devices.
The ASA has two LAN interfaces, 192.168.10.1/24 and 192.168.20.1/24.
There is also another router on the network that has its own WAN connection, its on 192.168.20.254(shares second subnet...
Does anyone have any examples of custom network analysis rules (advanced section of Access control policy). I have tuned the NA policy based on reassembly and fragmentation but I am trying to imagine a scenario where you would need a custom na rule. ...
