Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

We currently have a customer connecting to one of our sites via VPN tunnel. The Crypto ACL is configured for an internal subnet on our side. The customer has requested access to a couple of servers in a DMZ, but want to access the servers via the sam...

Hi All, I have been reading conflicting information. The setup I want to have is as follows. I will have 2 x 5516X (ASA1 and ASA2) I want to have two contexts on each ASA -  CTX1 and CTX2. CTX1 - Transparent ModeCTX2 - Routed Mode ASA1 to be active f...

GRANT3779 by • Spotlight
  • 3421 Views
  • 3 replies
  • 0 Helpful votes

Resolved! Dual ISP ASA 9.1

Trying to get a secondary ISP connection setup on a client's ASA, version 9.1. The issue I am having is that no traffic flows out the secondary connection when I disable the primary. I am assuming it has to do with NAT and/or ACLs but these are somet...

Resolved! ASA 5505 DNS Query

Hi I have ASA 5505 with software 9.2.4. I have one computer and its IP address is 192.168.1.200 and I have an internal domain controller with address 192.168.0.25. I wanted that this pc can do name resolution using this internal controller. So i have...

I have a Pix firewall with an UR license and it has Active/Active Failover. When I connect via console, it appears to be continuously reloading and cannot be interrupted. Only when I do esc while it's rebooting can I get the monitor> prompt. I have t...

Gerard Roy by • Level 5
  • 4449 Views
  • 17 replies
  • 0 Helpful votes

I found some other article regarding this issue, but I have tried everything and I have hit a dead end. I followed the procedure how to configure SFR and I could not ping the management interface, so I created IP on the management interface 192.168.2...

dovla091 by • Level 1
  • 2891 Views
  • 7 replies
  • 0 Helpful votes

Very basic question on firewall rules on the ASA. I have 2 interfaces. Lets call them LAN 1 & LAN 2. Both have the same security level. HOST A on LAN 1 should communicate with HOST B on LAN 2 on http only So the rule for LAN 1 interface is: Source: H...

louis0001 by • Level 6
  • 531 Views
  • 2 replies
  • 0 Helpful votes

Hi, We have a ASA firewall 5580 running on 8.4(4)5 version in Multiple mode (context 10). Customer has requested for an upgrade to test the URL Category filtering on the firewall. I have checked the upgrade path document but couldn't find the exact v...