Network Security

Hi all, Is it possible to migrate Microsoft Forefront Threat Management Gateway to Firepower Threat Defense? Thanks in advance.

I setup network discovery policy with a settings of discovering our LAN network, any zones, source & destination port inclusions none and Actions to discover are hosts, users and applications.  Unfortunately, I do not see any hosts discovered except ...

I have a pair of 555X in HA mode. Each have SFR modules. I have a Virtual FMC. I added 2 URL Filtering and 2 Malware licenses and the protection license into the FMC. I have added the modules into FMC.  I can't seem to allocate a URL license or Malwa...

My customer runs public IP Addresses on their network, some old legacy stuff and it will take some time before they fully upgrade to RFC1918.My question is : is there a way to classify IP Address they use as USA IP, right now shows up initiator Count...

Hi, I'd like to know what the built in threshold is for the CPU Temperature (not the ambient temperature) where the "show environment" command will start showing a warning or critical value. The reason for this is so that I can use the value on our ...

Hello, I am planning to implement ISE on our network. In the network there are multiple data centers.  Is it possible to have a standalone ISE setup on each data center? Is it possible to configure NAD with different ISE setups "two unrelated setups...

Hello, I have a pair ASA5525-X that were ordered at the same time that are identical.   When I do a show version I have one ASA reporting that it has 2 contexts while the other one is reporting 4. I wasn't aware that contexts were stackable. Do I hav...

Hi,one of my customers is using a Cisco ISA570 which originally has the security services with TrendMicro (embedded in the system).   I cannot find a way to renew the same service.  It looks like it is not being offered anymore or I am doing somethin...

Is there any way to get the total count of open  connections to a specific (destination)port via command line or GUI. For example, If i wanted to know many open NAT connections there are destined to port 80 and only port 80. I know you can use "sho...

Can we create multiple VRFs on ASA? If yes, then what would be the commands to do so?

I've just installed a brand new ASA 5525 and have set up some initial testing. I've /22 public address space to play with. I've set up a very basic static NAT to test connectivity from the internet. I have a device on the inside which I’ve done a sta...

Hi guy's, Im new to the ASA firewalling and try to migrate a asa 5520 to a asa 5506-x the 5520 is using Software Version 9.1 and the new 5506-x is using Software Version 9.6. I found some info about using the "backup filelocation" command which is ...