Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Dear Experts,Iam getting one error on my firewall and how can i fix this problem.Deny udp src MZ:10.242.100.20/49290 dst OUTSIDE:111.93.252.6/53 by access-group "MZ_access_in" [0x0, 0x0]How can fix this problem.please help mesrinivas

Hello,I can't figure this out.  I am sending logs from one ASA to our syslog server and it displays on the syslog server as the hostname of the ASA, however our other ASA shows its IP, how can I get the first ASA to send its logs and show as its IP a...

Andy White by Level 7
  • 10638 Views
  • 2 replies
  • 0 Helpful votes

Anyone know of an area where information on monitoring VNC traffic would be?I have been asked to monitor VNC traffic and the baseline signature I have loadedon devices seems a little lacking in scope....Anyone else looking at this traffic on their ne...

sweeneycj by Community Member
  • 1358 Views
  • 2 replies
  • 0 Helpful votes

Hi,Although my CSC-SSM module is down, I am stille getting the following error:%ASA-3-421001: TCP|UDP flow from interface_name:IP_address/port to interface_name:IP_address/port is dropped because application has failed. A packet was dropped because t...

chrisdims by Community Member
  • 1341 Views
  • 2 replies
  • 0 Helpful votes

Resolved! L-ASA5510-SEC-PL

Guys,I have to ASA 5510 with a base licence. I have 8.4 on both of the firewalls, and would like to configure active/passive.Do I need only one security plus lience or two,This text has been copied from cisco.com:http://www.cisco.com/en/US/prod/colla...

lyesouarti by Community Member
  • 4838 Views
  • 3 replies
  • 0 Helpful votes

Hi,Would like to know if the following behaviour is normal with a new setup on an ASA having security+ installed;  (or after a reset to factory defaults);is it normal that we can't access the server on the dmz (remote desktop for example) from the in...

We just brought up a new location and we do not have a WAN connection to the site yet.  Until that goes in I run a VPN tunnel between our main site and our new location.  While I have had no issue with getting connectivity between the sites, I have n...

joerggrau by Level 2
  • 1265 Views
  • 1 replies
  • 0 Helpful votes

Hello,I have found multiple solutions to this question for < 8.2 but no solutions for the new way the ASA does nat statmentsBasically i have multiple VLAN's and i need 2 of them to communicateinside - 192.168.1.0/24 ( security-level 100 )voice - 192....

All,I am updating my 8.2(3) code for my new ASA5512 that is running 8.6(1) and am unable to get on the internet with my current configuration from the inside interface.Information:Outside: ***.***.33.11Gateway: ***.***.32.9Inside: 192.168.215.0 /24dh...