Network Security

We are trying to set up our ASA 5505 that is running PPPoE so that we may access our ftp site using 99.23.119.78 to reach internal ip 192.168.1.3. Can someone tell me what I am missing?Here is my current config:Result of the command: "show running-co...

hi alli am trying to access asa firewall through asdm in lab (gns3 environment)ciscoasa(config)#  sh verCisco Adaptive Security Appliance Software Version 8.0(2)Device Manager Version 6.3(5)ciscoasa(config)# sh run asdmasdm image disk0:/asdm-635.bina...

We have a somewhat standard 3 interface dmz setupinside---dmz---outsidewe nat from inside to dmz for normal access of servers on dmz (with access rules)we have one web server on dmz we dont want to nat to reach from insidewe would like to have 1 fixe...

Hi All,Just looking for some good reasons why I should upgrade a Cisco PIX 515e cluster to an ASA Cluster to present to the business.If anyone has any good advice on why this should be done please share it with me.many thanksA

Hello all,When a new user is created with the "Must change password at next logon" check box ticked, ACS does not allow the user to change the password.  The password prompt just keeps popping up over and over.  Could anyone point me in the right dir...

I have IPS 4270  in promiscuous mode, as can I configure Attack Response Controller (ARC)  Blocking for Nexus 7010?IPS 4270 in promiscuous mode Do work with Nexus 7010?

Morning  I currently have a Cisco 887 running Trend filtering which is all running fine and blocking url's etc. I also have a Cisco 2960 and 3 x AP's running behind the 887. I have a VPN running on the 887 to enable us to connect remotely to the devi...

Hello,I'm using ASA 8.2(1) and ASDM 6.2(3)up to now all was workinf fine. But suddenly the Syslogs are nomore shown on ASDM.Has anybody a clue what the problem is?

I am about to replace a ASA 5510 with a ASA 5520.This ASA is configured for a variety of functions between firewall and SSL VPN.Am I able to simply to do a show start on the original and save that off and then paste that back into the replacement ASA...

HelloI'm a little confused, when should I use the command "mac-address auto"? I know that the ASA has some issues when doing multiple context. I read a few Cisco docs but it inst clear to me.I found the following doc about, but it has only a few exam...

Dear all,I have created static nat entries on my firewall. The problem is that those ips does not belong to the outside interface subnet.My device is not cisco so i cannot really paste a configuration that makes sense but i think it is more a network...

I need help with configuring a priority for printing applicationsHere is the scenario: Location A has a private IP range of 192.168.0.x and location B has a private IP range of 192.168.1.x. The priniting traffic starts from location A to location B. ...