Network Security

Hello,In my current setup i am using ASA5520 v8.3 to filter unwanted traffic  via ACL and NAT to different servers, everything running according to  plan but i am trying to create an ACL that will block  multiple simultaneous requests from one single...

Hello guys,I have system which works on Server/Client basis on a specific port number (udp 5000). The Server version of the system is in a remote location where as the client system is installed on more than 1 PC. Our network has a PIX firewall where...

Hello All,I am recently purchased 2 Cisco 5505 ASA for my network. I am having 2 ISP Connections. I want to connect these 2 connections to the 2 ASA's. Means ISP 1 to ASA 1 & ISP 2 to ASA 2.I want to do failover on this network. I dont have router in...

Hi,I want to configure FWSM in 6509 switch as a internal firewall : I have below doubts about FWSM configuration : To login to FWSM , i can go to the perticular session slot ..no proc ..no and login with username and password below is my scenario : I...

Hello Dear'sPlease find the attached i have made a Inline Pairing in IPS for port 1 and 3 and for port 2 and 4, Server is having 2 NIC cards both are active. Will there will be a issue in IPS Inline interface pairing packet forwarding.Only 1 ASA is a...

Wanted to upgrade the ASA to version 8.2. Current ASA version is 7.0(8) - see belowCurrently running AS 5520Cisco Adaptive Security Appliance Software Version 7.0(8)Device Manager Version 5.0(8)toLeased a ASA 5520Cisco Adaptive Security Appliance Sof...

I have a problem with ASDM of  two ASA 5520 when these are working with failover because if the primary is active and the secondary is passive, I can't access with ASDM  while if the primary is passive and the secondary is active I can access with AS...

Good morningI'm writing you to know information about hard disk in my Cisco IDS 4235, in particular look the output of the #show version command:4235zcom# sh versionsystem is using 17.8M out of 29.0M bytes of available disk space (61% usage)I don't r...

Hi All,I had configured AD integration on my CSC module without problem. The agent is installed directly on AD server (Windows 2003 R2 64 Bit)From User Identification Settings page seems to be all ok.After this, I had configured a policy for account ...

Hi All,"Request dropped" in url-server statistics. What does that mean?As  I understand, it means the url lookup request sent from ASA to websense  got dropped since no response or time out from websense server? Is this  correct? But how about the ot...