Network Security

I was executing a wr mem on my primary pix and now im not able to get into enable mode. I get a message about waiting for previous session to finish. Does it timeout or do i need to reboot it

Can u please tell me what these messeges say?1) %APPFW-4-HTTP_DEOBFUSCATE: Sig:14 Deobfuscation signature detected - HTTP deobfuscation detected IDS evasion technique from 172.31.0.71:15909 to 4.71.209.4:802) %APPFW-4-HTTP_STRICT_PROTOCOL: Sig:15 HTT...

Hi All,What's the correct pkg file for the IPS-4240-K9-sys-1.1-a-5.0-2.img for pkgKindly confirm the same

experts, we have a ASA active/standby setup and would like to have the standby firewall monitored as well via PING, but we can only ping the active firewall. The configuration on the firewall are identical. Please help.

Hi, I have a cisco pix 515e firewall, what is the latest version for this firewall ? is the latest firmware has any antivirus capabilities ?Thanks.

Through our ASA we can telnet to a email server but get 500 5.5.1 Command unrecognized: "XXXX" when we try to use the commands. Any help would be appreciated. Thanks.

In the vpn client : user authentication when i enter the username & password, the username & the password does not get authentified, what command should i put in the PIX 515E. Please wait for help.

hiI have a 3005 with 64mb RAM running ver 3.6.7B. maximum session it is displaying as 100- can i increase the no of max sessions by anyway- what will happen if 101th user connecting to VPN 3005, however i can see total cummulative session is 118. Doe...

Hi,I'm trying to setup public DNS Servers in a DMZ using an ASA 5505. The DNS server is also a web host and I can access the web server via port 80 using the static ip.The issue is that UDP dns requests are dropped:Deny udp src outside:68.87.71.227/2...

I have a topology where an ASA is the default gateway for the network.There is a network the ASA knows by other router in the inside network.Then when a host want to reach this network and goes to ASA as it is host's default gateway the ASA send the ...

what software version comes with the 5505 out of the box.

Hi all,I have the inside int with 100 sec level and on interface( different then outside) with 60 sec level.i have an ACL on the inside allowing IP TCP and UDP and also one ACL on the 2nd interface allowing the same.What should I do to enable the tra...

Hi,I now have a PIX 515E and VPN 3005 concentrator. Is it more secure to put it in line or to have them run parrellel (IE both have public facing interfaces). As the VPN is end of software line now ? Only going to be running webVPN from it - other VP...