Network Security

I believe I set thing up correctly on the c880 and I get this "DISABLED" for websense. Anybody know how to enable it?ip inspect name TEST http urlfilterip urlfilter server vendor websense 10.x.x.xip urlfilter server vendor websense 10.x.x.xTESTSTORE#...

when i try to configure redundant sub interfaces, i receive the following error.ASA1(config)# interface Redundant 1.2^ERROR: % Invalid input detected at '^' marker.ASA1(config)#anyone have any suggestionsCisco Adaptive Security Appliance Software Ver...

Hello, we tried to configure our new 5510 to secure a datacenter configuration in a level-3 static routing+access control configuration.Basically : - external IP is A - internal network is N, a public network routed through the 5510 - internal IP is ...

Hello all. I have a 5540 that I am having what I deem as odd ACL hits. The ASA is currently setup to allow traffic on the outside interface to a protected server on the inside interface. I currently have a permit ip any any applied to the inside inte...

Hi,Not sure if I'm going mad, but I can logon to my ASA via SSH and just enter my username and password and then the enable password, I can logon to the ASDM with the same credentials, but when I log into ASA via telnet I get a password screen and tr...

Hi,I have a VPN client behind a router 851 connect to an ADSL line. The VPN client version 5.0.04.0300 connect to an ASA5520 at the main office. Connection successful, but it take 60 seconds to get an access to the remote network. I swap the router 8...

Hi all,I need help what to use and how to do next.What we need is to create remote VPN for many users so that every user is member of more than one group and every group is linked to predefined set of rules, for instance you can access this IPs, port...

Hi, it is the first time I use a PIX, and I am having problems with NAT.I have a serveur with an Internal Ip address 192.168.230.13at the outside and ip addres is use 10.5.5.3So I did a translation rule to a static IP,from 10.5.5.3 on outside to insi...

The 6500 model WS-SUP720-3BXL with IOS version 12.2(18)SXD4,and IDS card WS-SVC-IDSM-2 with sw 5.0(2)is compatible to run on inline mode.Regards,Viraj

I have some problems with a program that won't initiate over a vpn link. Users on the 192.168.99.0 side, starts the program client. The client then contacts its database on 192.169.98.12, to load the program. The user credentials, clearly gets checke...

I have configured an ASA 5510 to be between an internet router and a cisco switch. I have 3 servers in my inside network which users access from outside and these servers also have public addresses, my inside user can connect to the internet,surf the...

On what scenarios an ACL is not applied to interface.

I connected my LMS 3.0 server to an ACS Server that went offline. Right now, I can log into the server with the local admin account, but it has no rights. I would like to restore the full rights to the local admin account so I can change the server i...