Network Security

Hi Everyone,I am hoping that someone on here can help me out, as I am going out of my mind with this issue that I've been working on for the last few days.I have a customer that has an ASA5510 behind their ISP router, and we are using it as a RAS VPN...

ciscoasa(config)# sh run: Saved:ASA Version 8.0(2)!hostname ciscoasaenable password xxxnames!interface Ethernet0/0 nameif outside security-level 0 ip address x.x.x.17 255.255.255.240!interface Ethernet0/1 nameif inside security-level 100 ip address 1...

Hi,Recently we have added a ASA firewall in our network.in that we are having 4 interfaces, 2 interfaces are with same security level one is inside interace and second one is MPLS interface,And we are able to access the ASDM of ASA from inside zone,b...

Does anyone have a solid, proven way of doing this?I have an ASA-8.03 version with an inside interface 172.16.0.1/24 and have another network via 172.16.0.2(router) to the network 192.168.10.0/24. I setup the "permit intra-interface traffic" command ...

Recently set up L2L VPN asa5510-asa5510. Our counterparts can browse network shares at our office, but I cannot browse them. I can ping them and connect to their internal webservers, but browsing errors out at network path was not found.

hi guysmy ASA5510 has been Security plus licensed, but I cannot find which is gigabit interface. Who can help me enable them, thanks.ciscoasa# sh versionCisco Adaptive Security Appliance Software Version 8.0(2) Device Manager Version 6.0(2)Compiled o...

Hi folks,I need your assistance on this...We are using a PIX 515e firewall on the edge of our network. Behind it a network, separated into VLANs (VLAN x has IP addresses 10.0.x.0/24 with x=11 to 17). Routing between VLANs is performed by a layer-3 ro...

NAC Network session never begins so client posture is not checkedExtract from logs on a working clientCTA Posture State service started7 23:36:53.218 07/04/2008 Sev=Info/4 CTASTATE/0x64400001Value written to the registry8 23:52:43.093 07/04/2008 Sev=...

Hi!I want to clear a connection in my ASA but I have found that "clear conn" command doesn't work with ASA falover.How can I clear a connection with this configuration?Thank youAlex

Hi, I have recently setup a remote VPN over ASA and its working fine. Now as per security concerned I want that client could able to use VPN connection by only their Laptops from outside Nework if they try to use like cyber cafe machines then It coul...

Hi,I am trying to put forward a NAC solution for our <very> small office - around 30 users. I think NAC's a great solution to enforce a tight security policy, and I want to ensure users connecting to our Data Centre have been properly (de)wormed I am...