Network Security

Not entirely sure how to explain this so here goes.Is it possible to use NAT/global or static statements for subnets not physically connected to the PIX ?Problem is we have run out of address space on our external interface and want to add a static n...

Can I use a 5580 ASA as my primary firewall/concentrator and use a 5550 as the failover device to it?

We need to upgarde the license for trend Micro license for the CSC of the ASA 5520. Recently we failed to access to the CSC. Finaliy It said that the Can not access the Management Port. Pls help on this

Hi all, I have a FWSM in a 7609 that is currently up and running in a single context, supporting our Internet access and customer circuits. We have a need to stand up a second context for our daughter company. I would like to know if there are any th...

Dear experts, can any one suggest good cisco security book which cover compleet pix and asa. Any security simulators Regards srini

Hi - When configuring the FWSM in transparant/bridging mode, is it neccesary to have an IP address on bridge-group 1 or can I omit it as all the contexts will be managed/accessed from the system context.Many Thanks

hello experts, my firewall has to wan interfaces wan1 and wan2, each one connected to a dsl router. and i configured the rules on the pix firewall to allow outgoing traffic from the lan out wan1 and wan2 but i discovered that wan1 only can connect th...

Hi,Is it unusual to see a Pix515 with 256MBof RAM? Is it even possible? See below:iscoPix> sh verCisco PIX Security Appliance Software Version 7.0(7)Compiled on Fri 06-Jul-07 10:37 by buildersSystem image file is "flash:/pix707.bin"Config file at boo...

Hello,I can't seem to get the ASDM to connect and display the IPS (ASA-SSM-10). I continue to get the "error loading module" when trying to connect via the ASDM. The command and control interface (G 0/0) is connected to the local net and is pingable ...

I have a customer with two ASAs; in Active/Standby. They want to purchase one AIP. Will failover (without the AIP functionality) to the Standby work if the AIP is configured for Promiscuous mode? Thanks, Bob

hi ,I need help, Can IDS event viewer version 4.1 monitor the IDS-4235-K9 with version 5.1-5-E1 ?

Hi There,We are currently looking at building out our Data Center to support a managed backup solution for multiple clients. We are currently looking at pushing the backups through a pair of ASA5580-20 appliances, however I have concerns as I haven't...