Network Security

the concurrent connections at FWSM suddenly increased after that the network become down if i make clear xlate , the problem disapear i decrease the timeout xlate from 14 hours to 3 hours but the problem still existing FWSM is running in multi contex...

I have a host in a lower sec that needs access to a router in a higher sec. I have an acl and routing to the inside for the destination network. Do i need to use a static nat for this? I also tryed to create a static nat to the router. But that didnt...

Hi i have a network running eigrp and my default gateway is the ASA 5510. THe network runs find but i want to set up remote connectivity through the other site incase they loose link with IPSEC tunneling. I have establish Ipsec between sites (ASA and...

what should be the ip address of aip-ssm module? from the inside network range? and what should be the default gateway? I cannot reach it...

Last night I upgraded our ASA 5510 platforms from 7.0 code to 7.2 code.I also shipped the new ASDM image to Flash (5.2.3).this morning I wanted to access the ASDM launcher,so I navigated to https://<address of ASA>. I attemtps to authenticate me to t...

Hello,My customer have a ASA 5550 in HA. It is the Internet Firewall.In this moment the firewall have 50.000 connection. Customer review the log in the syslog server and noted wich not all syslog messages the firewall are notify to the syslog server....

Does the PIX 515 ver. 6.2 support L2TP, IPSEC certificates through itself to a 2k3 server?

A network engineer was in the middle of setting up a customer ASA 5510 Firewall and left. We don't know the IP/UN/PW.Is there a way to hard reset the firewall back to manufacture settings?Thanks in advance.

Hi,I need to terminate the my internet link from ISP on my firewall directly.Old scenrio is something like that.ISP-->Link on ethernet (Cisco router)-->ASA firewall(Natting here)-->SwitchNow want to do something like this.ISP---->Link on ASA firewall...

My VPN go up only if i ping from a specific side.If i ping from the other side the VPN don't go UP and the message is MM_NOSTATEThe good side is pix.txt confThe bad side is pixe.txt conf

Hi,I have a Pix 525 firewall in my lab and i am practicing in it.I have connected two systems to inside and outside interface each.i have configured 172.25.15.1 as inside interface ip address and 172.25.30.1 as outside ip address i want the system wi...

Hi,i hav ePIX 515E firewall,from the console,I am not able to enter into if configuration to assign IP address,meanspixfw#conf tpixfw(conf t)#interface e0 here when I press enter it has to go to the ethernet interface prompt but it is not,instead it ...

After I restore the CSA MC 5.2.0.245. I am able to get everything back. I am able to ping the hosts so DNS is working. However the hosts is not register to the MC. Even the MC itself is not register. Is there anything I have to do after the restore?

Hi,I just took over management for a PIX running 6.3 only using conduits and outbound statements.Currently, there is no Internet (or outbound) access allowed generically speaking for the dmz lan.I have two questions:What are the thoughts of allowing ...