Network Security

Hi,I jus took over this network that has a ASA5510 box. I went through all the diagrams and detials and tried to connect to the Firewall via ASDM loaded in another machine.When i entered the IP,username and password it waits for sometime and gives a ...

CSA 5.2 agents are prompting a few of my hosts because the CSD is trying to modify other processes and even tries to modify the CSA on the host machine. How do i limit these prompts and get it to stop from trying to spawn off and do other things espe...

Hi,I have 1 ASA 5510.I have 2 internet links that i want to terminate into this very firewall. All internet traffic will go via thses links in a load balancing mode. I don't have any router in between.Can this be achieved? If so please suggest.

Hello,From a console connection with the interface configuration:name 172.16.204.198 pix_managename 172.16.204.200 fo_pix_manageinterface Ethernet2 speed 10 duplex full nameif manage security-level 80 ip address pix_manage 255.255.255.224 standby fo_...

I have an ASA5505 at home. Connected to a 10240/1280 DSL. I use a bit torrent client with a built-in scheduler set to connect to bit torrent-network at midnight and disconnect at 7 AM.Every morning my connection is dead.I can reach the asa with telne...

Hi all, Can someone help me please An inside server (192.168.92.6) need to access to a remote network 192.168.31.0. A VPN site to site is established between Pix outside (192.168.111.6) and Multitech Firewall (192.168.111.200). Now my inside server s...

Dear All,I have an issue configuring policy NAT. my design is attachedI've One SMTP Server with two IP adresses. the new is 10.3.25.2/24 and the old one 192.168.56.2/24. the first IP should replace the second after a period of time. I would like to t...

HiLet me explain our scenario.1. we have one Router and one PIX. Router is connected to the internet. And PIX is connected to inside. First I configured Router ann it was fine. We could browse to the internet and there is one email server at inside o...

I have an ASA (5510) that is running 8.02, it needs to terminate VPNs on its outside interface, I have developed what I believe is a good config but its not working, I get the following error message...Sep 13 04:37:42 [IKEv1]: Group = USERVPN, IP = x...

I need some help using the VPN wizard. First of all, the manual I have for the 515e says that PDM should be the GUI used to setup everything but this PIX has ASDM, is there a difference?I don't have a real public network to connect to right now, so I...

HiI've been playing around with altering alias entries on our pix and FWSM. It seems to me there is some timeout in effect when I make changes, clear xlate doesn't help anything.Example: On my windows network connected to FWSM I have set up one alias...

Hello All,I have a PIX 501. I configured it with Public IP add outside and private IP inside. I am able to connect to the device fron inside via telnet but NOT from outside. I configured the telnet access on both Interfaces with telnet command. I am ...

how is this kind of state possible on ASA?

Hi, My PIX 515 was initially loaded with 7.x image.One of the ram strip failed. I tried to load 6.x image ( now only 32MB ram ). But it gave an errorassertion "addr < STRATA_CHIPSIZE" failed: file "../flash/strata.c", line 222Is there any way to eras...