Network Security

How does an FWSM realize that an int is directly connected as there is no physical interface available.

Is it possible to configure a Pix 515E with two ports on the 'outside' and two ports on the 'inside' of a network and run OSPF at either side. Because the Pix would see the same network on both it's 'inside' ports with equal cost would it get confuse...

Hi Guys,I have a problem here with my setup.It is a simple one Internet <--> ADSL router <--> ASA <--> LANI have two lan interfaces both connected to my ASA. The problem is i have a FTP server residing inside my LAN. The users on the internet are not...

Hello, I have installed a FWSM 2.3(4) and when I change a policy for example and I intend to save the config, the PDM shows this error:"PDM received an error when one or more of the commands below were sent to the FWSM."Someone could help me please?T...

Hi, please advice,if we install a ASA5510-CSC10-K9, for a network of 35 pc and 2 servers, do we still need to install on each pc the trend micro anti virus or another anti virus application.

I am not sure if my VPN module is faulty, if it is causing the router to reload, I have enclosed the following logs.*Mar 1 00:00:22 GMT: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1/0, changed state to upMar 12 03:20:16 GMT: %CRYPTO-4-RECV...

Hi,Any one tried to configure a PIX firewall to proxy DHCP request through.I have a Central DHCP Server, and I want to use it for our clients placed on a other network, the only connection between the to networks a trough a PIX firewall.Illustrated.D...

could you anybody clarify me for the following queries with respect to Cisco CSM.Multiple customers support using NDGs - Is ACS mandatory for us to support this feature? Limitation on the number of customers / groups supported Log archival of securit...

I am new to the whole security world... ie. configuring pixes... I have a question, I was given (free) pix 515 with the two interfaces... I did a wr erase on it to start fresh, but wanted to test the ports for connectivity...I configured my outside i...

Hi all, We have a CISCO PIX 560e in our office. Connected between the Wall and the router. I have no idea how to even use this thing or even how to check if its working properly. It was setup before i came here and i have never had a need to touch it...

Can any one explain as how to add devices in Cisco works lms 2.6

We have a PIX 506 that we use for remote access VPN. It's setup with a local IP address pool for handing out addresses to remote clients.We've noticed that the addresses given out seem to increment over time as if they are not recycled back into the ...

hello,i have configured the client vpn on pix 515E and the user can connect successfully but they don't get any internal access to any servers also cannot browse internet. my config as following. ip address outside 213.2.3.4 255.255.255.240ip address...