Network Security

Dear Sir, I see the memory of IDSM is 99% (you can look the following attachment).Please show me how I can kill some processes to decrease memory?Thank you very much. Duy Khang - Security QTSC

Has anyone seen this error message from the CSC SSM module. Compact Flash storage is nearly out of space on InterScan for CSC SSM. Please contact Customer Support for assistance.I have seen this message twice in the last week or so but my system is s...

Hi,I have an situation with Policy NAT. I need to configure such that 1. client (outside) from 192.168.28.0 255.255.255.0 to global addr 10.1.1.1 will be translated to inside 172.16.1.12. client (outside) from 192.168.30.0 255.255.255.0 to global a...

Hi, I have a question about the physical setup of both of these. I have an ASA which is my internet firewall and the CSC-SSM. The inside of the internet firewall is connected to a Private DMZ. I have also connected the management of the CSC-SSM to...

a service on mars called csips (which goes and fetches the sensor events) keeps stopping and starting. When it stops we obviously get no events on mars and instead get 'inactive reporting device'. When I run pnstop and pnstart the service comes alive...

Hi,I had a pb with one of my ASA 5520. the box lose the config file. then I erase completly the disk0 to have a clean disk0. in ROMMON mode, if I upload the image to boot it's boot correctly but if i issued the command dir, there is no file on disk0....

Dear Sir, I have Catalyst 6513 + some module (detail in attachment file).Now, I want to configure IDSM on Catalyst 6513. You can based on the hardware on Catalyst 6513 and you recommend for me about the configuration.Thank you very much Duy Khang

hello i want to use a pix 506e to create at minimum 20 site to site tunnels that will all end at linksys rv042s that the 20 coustermers have. the website says it is possible to have up to 25 tunnels and the remaining tunnels i would like to use to ho...

Hi. I have two cisco 1812 with VPN,the VPN is OK, but i can?t see troung remote access with PCanyWhere o VNC is very loungly. I see black screen.Hola. Tengo dos cisco 1812 con vpn, la VPN esta bien pero no tengo acceso remoto con PCanyWhere o VNC, se...

I need to migrate from a Cisco PIX 501 running 6.3(5) and to a Cisco ASA 5505 with 7.2(1).The 501 is setup for several VPNs, all 3DES.I need to get the 5505 up as quickly as possible, can the config from the 501 be used? What do I need to look out fo...

I have the management interface connected to the network and set to manage only. I can access the ASA from the subnet it in, but not the rest of the network. I have the access rights for the subnet I'm trying to access the the ASA set for HTTPS and T...

okay, heres the situation. I have two PIX-515E's in a failover scenario. Primary PIX has a UR license and the Secondary PIX has a FO license. The Primary PIX has failed, it decided to hang and when manually rebooted it came up with the no config, jus...