Network Security

The CSAMC component of VMS uses the MSDE or SQL 2000 Server database. Now, if I am just installing the IDSMC and the SecMon for managing and monitoring IDS, what database is used by those components???

Hi all,could someone tell me if it is possible to modify Alarm level on event received by CSAMC??On other words, if an even is associated to Critical level, can i downgrade it to Informational?If not, how i can set alarm level on custom signature on ...

hellois it possible to disable a ipsec lan to lan tunnel with snmpset on a concentrator 3005? I found the following link http://www.cisco.com/warp/public/471/vpn3k_logout.html which shows how to terminate a tunnel.thanks for answers!Andre

We have a pix 525 at one of the sites I administer and one of the requirements was that external ssh sessions to servers inside do not timeout (developers etc working remotely using servers inside the net protected by the pix).The only way I was able...

Sig 4058 subsig 1 (IDS Signature UPnP LOCATION Overflow) was triggered on one of our sensors as what appears to me to be a false positive. From what I understand, the sig fires on a payload of 116 characters or more to service port 5000 TCP. The dest...

I want to block all traffic from an IP range. What would be the best way to do this? We have a pix 520 running 6.3(3).

Hi Friends,Can you help me to solve an issue? I need recovery one PIX Firewall from erroneos upgrade, my client upgrade his PIX 515E from version 6.1.4 to 7.0 without taking correct procedure. So, now there is a problem. The PIX bootup with 7.0 versi...

Dear All,I want to upgrade pix 520 software from 5.1 to 6.3.Pls let me know the required things to this jobThanksswamy

Hi,I have PIX 515e with OS 6.3(4) and I have one outside and two inside networks.right now I have these settings (config excerpt):...nameif ethernet0 outside security0nameif ethernet1 inside security100nameif ethernet2 half security50...access-list i...

Does the IPS have to be connected back-to-back with a cross-over cable with the firewall in Inline-mode, since it looks like we are not assigning any IP addresses to the sensor interfaces??

Hello, I have problem with MTU via L2TP multihop. Has anyone information what is sequence of operation, when tunnel switching is provided ? (when packet is switched into second tunnel, is compared with MTU before or after L2TP encapsulation) ?Thanks ...

I've found that I need the correct licence/liecences to do failover. However, I can't find out how to check if we already have the correct licences and how to GET the upgraded licence if not.

I have configured bandwidth reservation in my routersMy probelm is I am not getting any hits on the access-lists Eventhough data traffic is there as per the access-list and in the show policy-map interface output not seeing any packet count.This is m...

Does Cisco have any recommendations on putting CTA on servers and using NAC?This is more in anticipation of NAC on switches. If you have good physical security over how servers connect to and disconnect from a switch, and you have good control over s...