Network Security

Hi,I have 3 interfaces, outside, inside and DMZ. The DMZ servers are NAT'd to Public IP. I am allowing PUblic to access the DMZ servers via Public IP. eg:static (dmz, outside) 161.10.10.10 172.16.2.10 netmask 255.255.255.255staic (dmz, outside) 161.1...

Any ideas?A customer of mine has IPX running over private lines to customer sites and we wanted to set up a PIX on our end to have some sort of security in place. We enabled GRE on the outside interface and could pass traffic although very slow. So w...

--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...

I am new to Cisco PIX. We have a PIX 501 and I am not able to access the Device manager through the browser. I get a screen where it says the device manager is loading, but it doesnt go anywhere. BTW I am trying to access from a Windows 2003 Server. ...

Hi I have 2 networks: 10.120.1.0 and 10.125.1.0. This basically is connected on the 2 interfaces of Router i.e 10.120.1.0 to fa0/0 and 10.125.1.0 on fa0/1. The firewall 10.120.1.60 is connected on 10.120.1.0 and i am able to access internet from this...

One of our customer has pix 501 with 10 license, in sh ver command inside host is 10 and throughput is limited. They had only 5 users, now they have increased to 20 users.Randomly some times, for some users internet does not work and then starts work...

When I attempt to install Management Center for Cisco Security Agents 4.0 as part of the Cisco Works VMS 2.2 upgrade, the installation fails with the following error:"Configuring ssl mode for cmf apache... failed. Aborting installation."The server is...

I am trying to set up a PIX501 so that an outside W2K mobile user can IPSEC/L2TP into the "inside". I'm using PSK.It works perfectly without a NAT box in between, but when I have to cross NAT (using NAT-T), phase 2 negotiation fails. I have enabled N...

Hi,Have a bunch of sites connecting using 501's.(IPSEC)Two sites upgraded their dsl line and when trying to configure the VPN tunnel at each site to point to 6 other sites I was able to get 4 tunnels up with a lot of difficulties and I even had to bo...

Hi,I have two PIX with UR licence. Will I be able to use one as failover if I connect the ethernet interfaces back to back ? Thanking you in anticipation.Regards,Bipin

Hi Is there any central management tool available (freeware) to monitor a pool of PIXes?thanks!

In documents Cisco says it support 370 Mbps in clear text, but want to know if this is analogous to handle packets per second or if there´s a specification for packets.Want to know if this is the correct equipment to place in a network that will have...

Is it possible to add static routes to a PIX and have them work?Ex. PIX inside IP is 192.168.0.1VPN concentrator used for remote office VPN's: 192.168.0.2Remote office connecting via VPN: 192.168.10.0I want to add a static route on the pix to point t...

Hello,I am hoping that someone here has had some experience with automating the configuration of the Cisco PIX 506/506e series. I work for an event planning company and we travel all around the world setting up networks onsite that will run for about...