Network Security

Hello .. Is there a way to do simple URL filtering on the 501 without the use of websense or similar external products? I have searched through the postings in this forum but have been unable to find anything similar?Basically, using an acl or equiva...

Hi,We would like to use object group in our PIX configuration. Can you please let us know what version of software we need to upgrade the PIX to achieve that? Currently we are on version 5.2(5).Thanks.

We have a Pix 506 that has a VPN connection to a PIX 520. There is one client on the 520 side that loses the ability to connect to the data server on the 506 side of the network. All other hosts can communicate accross. If we remote to a pc on the...

Is there exist any command to reset the blocked connections in PIX-515E ver 6.2 ?

Is there a command on pix (v6.3.3) that would give a list of services (eg:http server) currently running on the pix? The "show service" doesn't really say much....thanks.

Hiaccess-list 101 permit tcp any any eq domainaccess-list 101 permit tcp any any eq 8080access-list 101 permit ip host 192.168.0.250 anydialer-list 1 protocol ip list 101The above ACL works fine if the router(801) is directly connected to the switch....

Issue:Need to cfg. PIX 525 with a 2950 dmz switch. Would like to make VLANS on switch. Do not wish to use router on a stick to route between VLANS. internetrouter |outside pix -- dmz switch (w vlans 2-6)inside prod networkIt is my understanding tha...

Even though the PIX is not a true router, with 6.3 version of OS, PIX supports Vlans and you can assign IP addresses to each vlan configured. Does the PIX truly route between these vlans ? When logical VLAN interfaces are created, a security value is...

Hello,I need to know if QPM can coexist on a server having already CiscoWorks 2000 LMS and/or RWan bundles installed.Thank youPatrice

Hi,in order to authenticate the users when they go to browse Internet I did a configuration using a PIX 515 and MS-IAS.It works fine except when the user reads mails with Internet links (using Outlook).For every Internet link into the message, the us...

I've read several related posts, but I can't quite figure out what I am doing wrong. This is my first time configuring a PIX.PIX 501 version 6.3(1) I'm trying to allow inbound SMTP traffic to an internal mail server. We have only a single IP addre...

Trying to FTP from inside to outside. It works with nat 0 but when I use a static mapping from a.b.c.148(inside address) to a.b.c.120(outside address) it will not work. They are in different subnets. The PIX seems to just ignore the packet. There is ...

On cisco routers if I issue a command that generates a lot of output, such as the show run, I have the option to break out of it by hitting Ctrl-C which avoids me having to spacebar my way through all of the output. How do I do the same on the PIX, t...

what will be my PIX outside Ip address when it is connected directly to the Router. suppose the routers e0=192.168.10.10 & dialer is ip address negotiated (since it is dialing out to the internet).LAN-----PIX?--------Router---------Internet